Results 111 to 120 of about 2,138,910 (305)
Design of a Multistable Finger Prosthesis with Programmable Metamaterials
This research article shows the development of a multistable programmble metamaterial for the use as a finger prosthesis. The material was designed on different hierarchical levels where the influence of geometrical parameters and combination of mechanical elements was explored.
Franziska Wenz +5 more
wiley +1 more source
Arctic fires in permafrost landscapes have become more frequent in recent years with record fire years in Eastern Siberia in 2019, 2020 and 2021. The consumption of organic layer and charring of the landscape can deepen active layer and long‐term ...
Sonam Wangchuk +6 more
doaj +1 more source
Fabrication Routes for Ionic Conducting Fiber Strain Sensors
Ionic conducting fiber strain sensors (ICFSs) offer compliant, textile‐integrable sensing. Thus far, the commercialization of ICFSs has been constrained by fiber fabrication routes. This review provides a fabrication‐centric analysis of ICFSs correlating processing strategies with material properties and scalability.
Leo John Kershaw +3 more
wiley +1 more source
As a continuation of Part 1 of ground support modelling involving large ground deformation by Saiang and Nordlund (2016) this paper presents the conceptual models and results from the typically observed cases throughout the Kristineberg mine.
Nordlund, Erling, Saiang, David
core +1 more source
Ground deformation reveals the scale-invariant conduit dynamics driving explosive basaltic eruptions. [PDF]
Ripepe M +18 more
europepmc +1 more source
This study examines Invar composites reinforced with titanium carbide (TiC) and titanium nitride (TiN) using laser powder bed fusion (LPBF). It presents the influence of reinforcements on microstructure, tensile properties, and thermal expansion. Results show that TiC effectively strengthens Invar while maintaining low thermal expansion, whereas TiN ...
Ayodeji Nathaniel Oyedeji +3 more
wiley +1 more source
Deformation and Energy Loss in a Basketball Bounce
The bounce of a basketball against the ground was recorded using a high-speed camera. The effect of the total deformation of the wall of the ball on the energy loss during impact was studied for impact speeds ranging from 3.2 ms-1 to 14 ms-1.
Intat Tochirakul
core
Rapidly Solidified High‐Strength Invar 36 Prepared by Planar‐Flow Melt Spinning
The Invar 36 alloy was rapidly solidified using the planar‐flow melt‐spinning technique. Ribbon samples with thicknesses ranging from 20 to 160 mm were produced. As the grain size of the ribbon decreased to sub‐micron levels, the hardness increased by more than 2 times.
Bekir Akgül, Mehmet Kul
wiley +1 more source
Ground deformation from ground-based SAR interferometry
An in-depth analysis of the last two images acquired by the ground-based InSAR system installed on Stromboli before the April 5th 2003 explosive event detected the precursory signals of the explosion related to ground deformation.
CASAGLI Nicola +6 more
core
Ground Deformation Rule Induced by Shield Tunneling Construction
In this paper, Ground deformation in shield tunneling construction is researched. It is put forward that ground deformation is caused by three reasons, which are ground loss, the positive thrust and the friction.
Xin Jiang Wei +3 more
core +1 more source

