Results 121 to 130 of about 181 (162)

Medium voltage multi-level inverters: Hardware-in-the-loop (HIL) simulations

2012 IEEE 27th Convention of Electrical and Electronics Engineers in Israel, 2012
This paper presents low cost flexible FPGA based HIL simulator and HIL simulation results for 5, 9, and 13-level topologies of medium voltage multi-level inverters that controlled by carrier based pulse-width-modulation (PWM) algorithm. The applications of these inverters can be synchronous or induction motors.
Raul Rabinovici, Dmitriy Tokar, Dmitry Baimel   +2 more
openaire   +1 more source

Electric Vehicle Charging Control System Hardware-In-the-Loop Simulation(HILS) with a Smartphone

2012
This paper presents EV(Electric Vehicle) charging control system HILS with a smartphone. The charging control system is consisted of an EV, an EVSE(Electric Vehicle Supply Equipment), a smartphone and EV-to-environment communication mechanism, where the mechanism is based on a smartphone core and on the Bluetooth.
Kyung-Jung Lee, Sunny Ro, Hyun-Sik Ahn
openaire   +1 more source

Materialflussmodelle für die HiL-Simulation*/Material Flow Models for HiL-Simulation – Simulating the material flow of machines in a Hardware-in-the-Loop simulation

wt Werkstattstechnik online, 2016
Bei einer Hardware-in-the-Loop (HiL)-Simulation wird die reale Steuerungstechnik mit einer experimentierfähigen Maschinensimulation verbunden. Soll das Bewegungsverhalten des Materialflusses in der Maschinensimulation zur Generierung von Steuerungssignalen berechnet werden, so müssen die harten Echtzeitanforderungen einer HiL-Simulation eingehalten ...
C. Scheifele, A. Lechler, A. Prof. Verl
openaire   +1 more source

Prototyping and Testing Power Electronics Systems Using Controller Hardware-In-the-Loop (HIL) and Power Hardware-In-the-Loop (PHIL) Simulations

2015 IEEE Vehicle Power and Propulsion Conference (VPPC), 2015
Prototyping and proper testing of the electrical control unit of electric vehicles under various load profiles and fault conditions is necessary to ensure maximum efficiency of the electric motors, batteries and power electronics. Hardware-in-the-loop simulation and power hardware-in-the-loop offer means to prototype and test various controllers while ...
Michel Lemaire, Pierre Sicard, Jean Belanger   +2 more
openaire   +1 more source

Alternative hardware-in-the-loop (HIL) setups for real-time simulation and testing of microgrids

2016 IEEE 1st International Conference on Power Electronics, Intelligent Control and Energy Systems (ICPEICES), 2016
The fruitfulness of the microgrids' installation depend upon the design of effective control system that can commendably handle various uncertainties such as renewable energy intermittencies, dynamic variations of nonlinear/reactive loads, disturbances during connect/disconnect with utility grid, faults, inverter failures, etc.
Y.V. Pavan Kumar, Ravikumar Bhimasingu
openaire   +1 more source

A Testing Technique of Microgrid EMS using the Hardware-in-the Loop Simulation (HILS) System

International Journal of Energy, Information and Communications, 2014
A microgrid is composed of distributed power generation systems, distributed energy storge systems, loads as a small scale power system. Generally, the microgrid is operated by an energy management system (EMS). In this paper, a testing technique for a microgrid EMS using the hardware-in-the-loop simulation (HILS) technique is introduced.
Ji-Hye Lee, Nam-Dae Kim, Hak-Man Kim
openaire   +1 more source

An In-Cycle Hardware in the Loop (HiL) Simulator for Future Engine Control Strategy Development

SAE Technical Paper Series, 2004
<div class="htmlview paragraph">Conventional engine HiL simulators use Mean Value (MV) modelling techniques to represent the plant and provide closed loop feedback parameters to the ECU. Once configured, these models require parameterising with the engine specific data. This data can be obtained from two primary sources:</div> <div class=
Graham Hunt, Anthony Truscott, Andrew Noble   +2 more
openaire   +1 more source

Hardware in the Loop (HIL) simulation of Multi Device Interleaved Boost Converter (MDIBC)

2016 IEEE International Conference on Power and Energy (PECon), 2016
This paper presents a Hardware in the Loop (HIL) simulation technique for Multi Device Interleaved Boost Converter. The main advantage of this technique is to make sure the converter could operate in right way, even if the real time experimental set-up is not completely available.
Maaspaliza Azri, Nur Hidayah Abu Khanipah, Muhammad Afif Mat Nasir, Zulkifilie Ibrahim, Azrita Alias, Nasrudin Abd. Rahim   +5 more
openaire   +1 more source

Powertrain and Chassis Hardware-in-the-Loop (HIL) Simulation of Autonomous Vehicle Platform

SAE Technical Paper Series, 2017
<div class="section abstract"><div class="htmlview paragraph">The automotive industry is heading towards the path of autonomy with the development of autonomous vehicles. An autonomous vehicle consists of two main components. The first is the software which is responsible for the decision-making capabilities of the system. The second is the
openaire   +1 more source

Hardware in the Loop Simulation (HIL) for Vehicle Electronics Systems Testing and Validation

SAE Technical Paper Series, 2005
<div class="htmlview paragraph">This Paper discusses the experiences on the Implementation and benefits of Hardware in the Loop (HIL) Simulation based validation systems used at TATA MOTORS for Engine Management System ECU software verification and testing.
openaire   +1 more source