Results 41 to 50 of about 150,292,712 (200)
International Journal of Automation Technology, 2007 The use of gantry crane systems for transporting payload is very common in industrial applications. However, moving the payload using the crane is not an easy task especially when strict specifications on the swing angle and on the transfer time need to be satisfied.
Wahyudi 0001, Jamaludin Jalani
openaire +2 more sources
Hardware-in-the-loop Rendezvous Simulation using a Vision Based Sensor [PDF]
, 2011 One of the critical issues of a satellite On-Orbit Servicing (OOS) mission is to ensure a safe and reliable Rendezvous and Docking (RvD) process. This most risky part of the mission must be carefully analyzed, simulated and verified before the mission ...
Boge , Toralf +2 more
core
Analysis and Design of DC-Bus Voltage Controller of Energy Storage Systems in DC Microgrids
IEEE Access, 2019 In this paper, a novel voltage controller of energy storage system (ESS) in DC microgrids (DC-MG) is proposed to enhance the DC-bus voltage stability. At first, a mathematical model of the DC-MG is developed in a state-space form.
Yoon-Cheul Jeung +2 more
doaj +1 more source
Computer Applications in Engineering Education, Volume 34, Issue 6, November 2026.ABSTRACT Fuzzy logic control is well known for its robustness across various automation engineering applications. Its structured linguistic modeling of human expertise and empirical knowledge makes it attractive to both students and control engineers. However, such expertise can only be developed through practice and trials. Existing solutions are time‐
Mohammed Chaker Boutalbi +3 more
wiley +1 more source
Nihon Kikai Gakkai ronbunshu, 2017 Fundamental study on a method to reduce the primary bending vibration for magnetically levitated (maglev) vehicles is conducted. These vehicles composed of lightweight car bodies are subject to elastic vibration; therefore, reduction of bending vibration
Masashi KABUTOMORI +3 more
doaj +1 more source
IET Power Electronics, 2023 In this paper, a modified submodule (MSM) method is proposed to reduce capacitor voltage fluctuation by integrating a bidirectional buck‐boost type active power decoupling (APD) circuit into each SM for the low‐frequency operation of a converter system ...
Van‐Thang Nguyen +4 more
doaj +1 more source
Energies, 2021 This paper proposes an enhanced control strategy for mitigating state-transition oscillations in active and reactive power responses of self-synchronized converter system to secure the islanded power system stability.
Ki Ryong Kim +3 more
doaj +1 more source
Wind Energy, Volume 29, Issue 10, October 2026.ABSTRACT This paper proposes a novel genetic algorithm‐based proportional–integral super‐twisting sliding mode control (GA‐PI‐ST‐SMC) strategy for the rotor‐side converter of a 1.5 MW doubly‐fed induction generator (DFIG) operating in marine renewable wind turbine (MRWT) systems.
Habib Benbouhenni +3 more
wiley +1 more source
Water Research XThis paper presents an operational Hardware-in-the-Loop Simulation (HILS) framework that extends the classical Benchmark Simulation Model No 2 (BSM2) from offline simulation to real-time and accelerated execution environments.
Iulian Vasiliev +3 more
doaj +1 more source
Wind Energy, Volume 29, Issue 10, October 2026.ABSTRACT For a newly emerging kind of cascade dual‐rotor wind turbine (CDR‐WT), the coordinated control of its front and rear rotor faces significant challenges. To solve this problem, a novel modeling and control design approach is presented in this paper.
Yang Hu +3 more
wiley +1 more source