Results 81 to 90 of about 294,653 (299)

3D‐Printed Sulfur‐Derived Polymers With Controlled Architectures for Lithium‐Sulfur Batteries

open access: yesAdvanced Functional Materials, EarlyView.
Rheology‐guided formulation design for direct ink writing enables the fabrication of 3D sulfur copolymer cathodes with controlled architectures for lithium‐sulfur batteries. The printed electrodes exhibit multiscale porosity and high sulfur utilization, delivering enhanced electrochemical performance compared to conventional cast electrodes.
Bin Ling   +7 more
wiley   +1 more source

Iron Loss Analysis of PMSM in Different Driving Conditions

open access: yes机车电传动, 2012
The amount of PM iron loss varied according to different driving conditions. In this paper, the actual current of the prototype motor was used to perform 2D finite -element analysis and obtain the flux-density waveform in conditions of no-load, maximum ...
王鹏, 陈阳生, 陈致初
doaj  

Review of Ship Microgrids: System Architectures, Storage Technologies and Power Quality Aspects

open access: yesInventions, 2017
Ship microgrids have recently received increased attention, mainly due to the extensive use of power electronically interfaced loads and sources. Characteristics of these microgrids are similar to islanded terrestrial microgrids, except the presence of ...
Shantha Gamini Jayasinghe   +4 more
doaj   +1 more source

Wave processes in alternating current traction network depending on parameters of power supply system [PDF]

open access: yesОмский научный вестник, 2019
The article considers a mathematical model of the AC traction power supply system taking into account stationary and nonstationary wave processes. The model allows you to analyze the effect of system parameters on electromagnetic processes at its ...
T. V. Kovaleva   +2 more
doaj   +1 more source

Non-Integral AC Capacitor Voltage Calculation Method for Shunt Hybrid Active Power Filter

open access: yesIEEE Access, 2023
This paper introduces a novel non-integral method for calculating AC capacitor voltage in shunt hybrid active power filters (SHAPFs). These filters commonly use passive power filters (PPFs) that can introduce voltage containing harmonics into the AC ...
Hyunjae Lee, Jingeun Shon
doaj   +1 more source

Assessing the effects of power quality on partial discharge behaviour through machine learning [PDF]

open access: yes, 2010
Partial discharge (PD) is commonly used as an indicator of insulation health in high voltage equipment, but research has indicated that power quality, particularly harmonics, can strongly influence the discharge behaviour and the corresponding pattern ...
Bahadoorsingh, S.   +4 more
core  

2D Magnetic and Topological Quantum Materials and Devices for Ultralow Power Spintronics

open access: yesAdvanced Functional Materials, EarlyView.
2D magnets and topological quantum materials enable ultralow‐power spintronics by combining robust magnetic order with symmetry‐protected, Berry‐curvature‐driven transport. Fundamentals of 2D anisotropy and spin‐orbit‐coupling induced band inversion are linked to scalable growth and vdW stacking.
Brahmdutta Dixit   +5 more
wiley   +1 more source

Accurate harmonics mitigation for water desalination plant supplied by multi-energy sources based on deep learning algorithms

open access: yesAlexandria Engineering Journal
This research concerns the water desalination plant supplied by multi-energy sources to reduce production costs and minimize environmental impact. The multi-energy system has solar modules added to the grid sources.
Hasnaa M. El-Arwash   +2 more
doaj   +1 more source

Harmonics suppression effect of the quasi-periodic undulator in SASE free-electron-laser

open access: yes, 2013
In this paper, the harmonics suppression effect of QPUs in SASE FEL is investigated. The numerical results show that the harmonics power is reduced by using QPUs, but the fundamental radiation power also has a pronounced decrease as the saturation length
Jia, Qi-Ka, Li, He-Ting, Wu, Ai-Lin
core   +1 more source

Harmonic analysis

open access: yes2004 IEEE Electro/Information Technology Conference, 2004
This paper describes a method of calculating the transforms, currently obtained via Fourier and reverse Fourier transforms. The method allows calculating efficiently the transforms of a signal having an arbitrary dimension of the digital representation by reducing the transform to a vector-to-circulant matrix multiplying.
openaire   +2 more sources

Home - About - Disclaimer - Privacy