Results 201 to 210 of about 701,963 (354)

Radiative Component of Heat Transfer in Mold Flux Film for Continuous Casting of Steel Analyzed by Monte Carlo Method

, 1997
Hiromichi Ohta, Hiroyuki Shibata, Toshihiko Emi, Yoshio Waseda   +3 more
openalex   +2 more sources

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

The Knudsen Layer in Modeling the Heat Transfer at Nanoscale: Bulk and Wall Contributions to the Local Heat Flux. [PDF]

Entropy (Basel)
Munafò CF, Nunziata M, Sellitto A.
europepmc   +1 more source

High heat flux reduction to materials using current filaments. [PDF]

Sci Rep, 2023
Le T, Suzuki Y, Hasegawa H, Moritaka T, Ohtani H.   +4 more
europepmc   +1 more source

Heat Flux Measurement using Infrared Thermography : The development and validation of a novel measurement method

, 2017
Erik Westergren
openalex   +1 more source

Engineering Deformation and Failure in Diamond Triply Periodic Minimal Surface Lattices via 3D Wall‐Thickness Grading

Advanced Engineering Materials, EarlyView.
The work demonstrates that strategic wall‐thickness grading in diamond triply periodic minimal surface lattices enables precise tuning of deformation and failure behavior under compression. Different gradation patterns guide how and where the structure collapses, improving energy absorption or promoting controlled brittle failure.
Giovanni Rizza, Danilo Bruson, Manuela Galati, Luca Iuliano   +3 more
wiley   +1 more source

Predicting boiling heat flux, heat transfer coefficient, and regimes Non-intrusively using external acoustics and deep learning. [PDF]

Sci Rep
Lim D, Liu Y, Bang IC.
europepmc   +1 more source

Heat flux concentrators based on nanoscale phononic metastructures. [PDF]

Nanoscale Adv, 2023
Zhang J, Zhang H, Li W, Zhang G.
europepmc   +1 more source

DESIGN AND TESTING OF A HIGH-HEAT-FLUX ELECTRON-BOMBARDMENT HEATER.

, 1968
R.D. Carlson, R.E. Holtz
openalex   +2 more sources

Removing Homocoupling Defects in Alkoxy/Alkyl‐PBTTT Enhances Polymer:Fullerene Co‐Crystal Formation and Stability

Advanced Functional Materials, EarlyView.
PBTTT‐OR‐R, a C14‐alkoxy/alkyl‐PBTTT polymer derivative, is of substantial interest for optoelectronics due to its specific fullerene intercalation behavior and enhanced charge‐transfer absorption. Comparing this polymer with (S) and without (O) homocoupling defects reveals that PBTTT‐OR‐R(O) forms stable co‐crystals with PC61BM, while PBTTT‐OR‐R(S ...
Zhen Liu, Jochen Vanderspikken, Paola Mantegazza, Stefania Moro, Mouna Hamid, Sigurd Mertens, Niko Van den Brande, Laurence Lutsen, Vincent Lemaur, David Beljonne, Giovanni Costantini, Koen Vandewal, Bruno Van Mele, Wouter Maes, Bart Goderis   +14 more
wiley   +1 more source