Results 81 to 90 of about 17,833 (305)
Analysis of micro-channel heat sinks with rectangular-shaped flow obstructions
, 2016 It is recognized that cooling methods incorporating micro-channel heat sinks with high capacities of heat removal are necessary for cooling of electronic devices.
Xie, Gongnan +4 more
core +1 more source
Advances in Magnesium‐Based Thermoelectrics: A Critical Review
Advanced Materials, EarlyView.Magnesium‐based thermoelectric materials have emerged as promising candidates for low‐to‐mid‐temperature energy conversion due to their abundance, low cost, and competitive performance. This review summarizes recent advances in Mg3X2, MgAgSb, and Mg2X systems, covering transport mechanisms, fabrication strategies, stability challenges, and device ...
Li‐Min Zhang +5 more
wiley +1 more source
Die Casting of Lightweight Thin Fin Heat Sink Using Al-25%Si
MetalsThe demand for lightweight and cost-effective heat sinks is increasing. A typical method for economically manufacturing complex-shape heat sinks is die casting.
Toshio Haga, Hiroshi Fuse
doaj +1 more source
Flow patterns and heat transfer for flow boiling in small to micro diameter tubes
, 2008 An overview of the recent developments in the study of flow patterns and boiling heat transfer in small to micro diameter tubes is presented. The latest results of a long-term study of flow boiling of R134a in five vertical stainless steel tubes of ...
Karayiannis, TG +3 more
core
Application of planar laser-induced fluorescence measurement techniques to study the heat transfer characteristics of parallel-plate heat exchangers in thermoacoustic devices [PDF]
, 2010 This paper describes the development of an experimental arrangement and the application of acetone-based planar laser-induced fluorescence (PLIF) measurement techniques to study the unsteady characteristics of heat transfer processes in the parallel ...
Artur J Jaworski +8 more
core +1 more source
Advanced Materials, EarlyView.Ultrathin lithium metal anodes (≤15 µm) offer a promising route to high‐energy‐density batteries due to their high capacity and low potential. This review presents design principles for ultrathin Li, evaluates fabrication strategies, and discusses challenges in liquid and solid‐state cells.
Cheng Wang +9 more
wiley +1 more source
Natural convection heat transfer effects with micro finned structures
, 2009 This paper was presented at the 2nd Micro and Nano Flows Conference (MNF2009), which was held at Brunel University, West London, UK. The conference was organised by Brunel University and supported by the Institution of Mechanical Engineers, IPEM, the ...
2nd Micro and Nano Flows Conference (MNF2009) +4 more
core
Heat transfer enhancement for thermal energy storage using metal foams embedded within phase change materials (PCMs) [PDF]
, 2010 In this paper the experimental investigation on the solid/liquid phase change (melting and solidification) processes have been carried out. Paraffin wax RT58 is used as phase change material (PCM), in which metal foams are embedded to enhance the heat ...
Zhao, Changying +5 more
core +1 more source
Advanced Materials, EarlyView.The performance of Cu‐based photocathodes in photoelectrochemical CO2 reduction is not governed by catalytic sites alone, but by the dynamic journey of photogenerated carriers. This review decodes how carrier generation, recombination, transport, accumulation, extraction, and electrolyte coupling shape catalytic activity, selectivity, and stability ...
Yi‐Cheng Wang +5 more
wiley +1 more source
SPE PolymersPrototype development nowadays can rarely be imagined without 3D printing. In the fast‐moving electronics industry, 3D printing is a good way to react quickly to changing developments, for example, when it comes to heat sinks made of thermally conductive
Nina Moser +4 more
doaj +1 more source