Results 31 to 40 of about 14,564 (307)
In the testing laboratories of Ukraine, there is no high-voltage equipment of the necessary energy for testing surge arresters for explosion safety, which does not allow to estimate this indicator at the stage of development of prototypes.
Yu. N. Shumilov, V. I. Bondarenko
doaj +1 more source
THE PURPOSE of the article is to discuss an updated survey of the technical condition of porcelain high-voltage insulators of the type IOS 110/400, which had defects with partial discharge intensities above 4 nC, at Tatenergo substations. The experiments
V. A. Golenishchev-Kutuzov +5 more
doaj +1 more source
Publisher Copyright: © 2013 IEEE.The present article describes a smart wireless online device for the severity monitoring of the contaminated insulators of high voltage transmission networks.
Mahmoud, Karar +4 more
core +1 more source
High voltage insulation properties of HFO1234ze [PDF]
ISSN:1558 ...
Koch, Myriam, Franck, Christian
openaire +1 more source
ON THE NEED TO INCREASE THE RELIABILITY OF LINEAR INSULATORS FOR DISTRIBUTION NETWORKS 10-20 KV
Introduction. In Ukraine high voltage overhead distribution lines (OL) of class 6 and 10 kV are the most extended. Their total length exceeds 280,000 km. More than 95% of the lines are made on line supports from reinforced concrete racks. On all poles of
Yu. N. Shumilov +2 more
doaj +1 more source
Railway system insulators are affected by pollution, altitude, and other environmental situations during operation, which causes reduced electrical performance or even flashover accidents.
Siyi Chen +4 more
core +1 more source
The damage of high-voltage terminal shed of composite insulators can influence the flashover performance of the insulators. The study was carried out experimentally to investigate the flashover characteristics of composite insulators with sheds damage at
Lu Ming, Li Yangyang, Hu Jianlin
doaj +1 more source
In order to further improve the insulation performance of fiber reinforce plastic (FRP) materials used in electromagnetic pulse (EMP) simulators, the flashover characteristics of FRP materials with different surface roughness and groove, i.e., those who ...
Linshen Xie +7 more
core +1 more source
Mechanisms for surface potential decay on fluorinated epoxy in high voltage DC applications [PDF]
Epoxy resin has been extensively used for decades as an insulation material in high voltage transmission systems. However, this insulation material does suffer from bulk and surface charging when used as insulating spacer, mainly in high voltage DC ...
Z. An +7 more
core +1 more source
Global experience of HVDC composite insulators in outdoor and indoor environment
High-voltage direct current (HVDC) transmission is known as green-energy transfer technology and has recently become an attractive alternative of high-voltage alternating current (HVAC) due to its high-power transmission capability and lower power loss ...
Akbar Mohammad, Mehmood Basharat
doaj +1 more source

