Results 1 to 10 of about 6,154 (303)
The Prediction of liquid holdup in horizontal pipe with BP neural network
Energy Science and Engineering, 2020 Liquid holdup is one of the most critical factors for the formation of pipe effusion, which is closely related to the efficiency of pipe transportation.
Rongge Xiao +5 more
exaly +2 more sources
Photoelectric Composite Three-Phase Flow Sensor for Complex Oil and Gas Wells [PDF]
SensorsReliable measurement of multiphase flow is fundamental to production evaluation in complex oil and gas wells. However, conventional sensors often suffer from low integration, limited measurement capability, and potential environmental impact.
Qiang Chen +4 more
doaj +2 more sources
Modelling and optimization of an existing onshore gas gathering network using PIPESIM [PDF]
HeliyonPakistan has limited natural gas reserves, and most are found onshore. This article reports on the problems of an onshore gas gathering network (GGN) analysed through steady-state simulation modelling using PIPESIM software.
Iftikhar Ahmed +6 more
doaj +2 more sources
Characteristics of Bubbles and Gas Holdup In A Two-Phase Column For Different Liquid Phases [PDF]
Engineering and Technology Journal, 2007 Experimental study of gas holdup (Eg), bubble diameter (dvs) interfacial area(a) m-1, small bubble rise velocity (Ubs), and bubble rise velocity (Ubr) in (0.1mi.d) and (1.5m) high column operated at ambient temperature and pressureconditions.
Auroba. Abdullah
doaj +1 more source
ChemEngineering, 2021 Newly novel developed correlations were derived to predict the dispersed phase (DP) holdup in a rotating disc contactor (RDC) extraction column. DP holdup is one of the significant parameters in the design of liquid–liquid contactors and for calculating ...
Ayham M. I. Al-Rahawi +6 more
doaj +1 more source
The gas holdup in a multiphase reciprocating plate column filled with carboxymethylcellulose solutions [PDF]
Journal of the Serbian Chemical Society, 2005 Gas holdup was investigated in a gas–liquid and gas–liquid-solid reciprocating plate column (RPC) under various operation conditions. Aqueous carboxymethylcellulose (sodium salt, CMC) solutions were used as the liquid phase, the solid phase was spheres ...
I. S. STAMENKOVIC +5 more
doaj +3 more sources
Influence of the geometry on the riser gas holdup in an external-loop airlift reactor: empirical and neural network modelling [PDF]
Acta Periodica Technologica, 2018 Experimental studies on the effect of geometrical characteristics (restriction orifice free area and sparger configuration) on the riser gas holdup of an external-loop airlift reactor have been conducted in this paper. The impact of the addition
Lukić Nataša Lj., Jokić Aleksandar I.
doaj +1 more source
Measurement Science Review, 2023 Flow rate and holdup are two essential parameters to describe oil-water two-phase flow. The distribution of oil-water two-phase flow in the pipeline is very uneven, and there is a significant slippage between the phases.
Han Lianfu +3 more
doaj +1 more source
Engineering Applications of Computational Fluid Mechanics, 2022 This research describes the dynamic behavior of an isolated slug driven by pressurized air in a voided line with an end orifice. A three-dimensional (3D) computational-fluid-dynamics (CFD) model is used to simulate the rapid propulsion and impact at the ...
Junling He +6 more
doaj +1 more source
Gas Holdup in Turbulent Bed Contactor: Experiments and Prediction Model [PDF]
Kemija u Industriji, 2022 Knowledge of gas holdup is important for the development of the three-phase fluidized bed reactors. This work concerns the study of the effect of different operating conditions on gas retention in a turbulent bed contactor type 2 (TBC), such as ...
Bensaber Bensebia +2 more
doaj +1 more source