Results 161 to 170 of about 18,015 (264)

Optical Signature of Moiré Superlattices Formed by Twisted SrTiO3 Membranes

open access: yesAdvanced Functional Materials, EarlyView.
We discover optical signatures from bonded interfaces in twisted SrTiO3 moiré superlattices, including low‐frequency Raman vibrational modes and strong second‐harmonic generation, consistent with strong interlayer coupling inferred from cross‐sectional electron microscopy and ab initio calculations. ABSTRACT Moiré superlattices formed at the interfaces
T. A. M. Ragib Shahriar   +13 more
wiley   +1 more source

Non‐Monotonic Changes in the Thermal Conductivity of Conjugated Polymer Films with Increasing Levels of Chemical Doping

open access: yesAdvanced Functional Materials, EarlyView.
Thermal conductivity changes non‐monotonically as regioregular (RR) and regiorandom (RRa) P3HT films are doped with F4TCNQ as a function of the extent to which P3HT is doped: an increase in thermal conductivity is observed upon lightly doping P3HT compared to the undoped film, followed by a decrease in the heavily doped regime. ABSTRACT The performance
Reid W. Wilson   +9 more
wiley   +1 more source

Electrospun Wood‐Derived Biopolymers as Electrodes in Electrochemical Energy Storage Technologies

open access: yesAdvanced Functional Materials, EarlyView.
Electrospinning transforms wood‐derived cellulose and lignin into architecturally defined, binder‐free carbon electrodes with tuneable porosity and functionality. This review shows how fibre design enables decoupled charge and mass transport, enhancing performance across battery systems, while identifying key challenges in spinnability, scalability ...
Michael W. Thielke   +3 more
wiley   +1 more source

Gate‐Programmable Linearization of Atomically Thin Nanoelectromechanical Resonators via Duffing Nonlinearity Cancellation

open access: yesAdvanced Functional Materials, EarlyView.
Gate bias is used to cancel Duffing nonlinearity in atomically thin MoS2 drumhead resonators, switching their response from hardening to softening and creating a nearly linear operating point. This electrical control suppresses hysteresis, enables stronger linear drive, and improves signal‐to‐noise ratio, offering a practical route to stable 2D NEMS ...
Pengcheng Zhang   +3 more
wiley   +1 more source

Performance Enhancement of Tin Chloride‐Incorporated Ferroelectric Polymer‐Based Artificial Synapse for Hardware Neural Networks

open access: yesAdvanced Functional Materials, EarlyView.
This paper proposes a highly efficient ferroelectric artificial synapse device based on an oxide semiconductor and SnCl2‐inserted P(VDF‐TrFE) gate dielectric layer. This FeFET significantly improved the synaptic performance due to the ion‐dipole interaction.
Hyun‐Soo Kim   +14 more
wiley   +1 more source

Ultrawide Bandwidth Optomechanical Magnetometry Using Flux Concentration

open access: yesAdvanced Functional Materials, EarlyView.
High‐permeability flux concentrators enable ultrawide‐bandwidth chip‐scale optomechanical magnetometry by exploiting magnetic nonlinearity to up‐convert low‐frequency fields to the mechanical resonance, where sensitivity is optimal. This enables flat wideband operation over more than four orders of magnitude, from tens of kilohertz to sub‐hertz ...
Benjamin J. Carey   +6 more
wiley   +1 more source

Fusogenic RNA Nanomodules for Fusion‐Mediated and Multiplexed siRNA Delivery

open access: yesAdvanced Functional Materials, EarlyView.
A fusogenic lipid‐layered RNA nanomodules (L‐CRAMs) enable high‐capacity and long‐lasting siRNA delivery through membrane fusion. These nanomodules carry exceptionally large siRNA payloads, avoid conventional endosomal uptake, and release multiple functional siRNAs through Dicer‐mediated processing.
Sunghyun Moon   +5 more
wiley   +1 more source

Magnesium‐Based Transient Bioelectronics, Bio‐Optics and Bio‐Scaffolds

open access: yesAdvanced Functional Materials, EarlyView.
This paper reviews the state of the art and recent advances in magnesium‐based thin‐film, foils, and scaffolds for applications in transient bio‐optics, bioelectronics and tissue engineering. The design principles, fabrication methods, material properties, and integration strategies are discussed in detail.
Massimo Mariello, Yves Leterrier
wiley   +1 more source

Home - About - Disclaimer - Privacy