Results 1 to 10 of about 128,095 (141)
CES Transactions on Electrical Machines and Systems, 2021 This paper deals with an analytical method to effectively calculate the inductance of an exterior-rotor switched reluctance motor (SRM), which evaluates the winding inductance of both the active section and the end section, accounting for the influence ...
Minjie Zhang, Nasir Ali, Qiang Gao
doaj +1 more source
Comparison of Two DC Motor Speed Observers on Sensorless Speed Control Systems
Jurnal Nasional Teknik Elektro dan Teknologi Informasi, 2022 In a sensorless motor speed control system, the motor speed is not directly measured using a speed sensor, but it is estimated using an observer. The sensorless speed control systems are mostly applied to AC motors, while they have not been widely ...
Bernadeta Wuri Harini, Martanto, Tjendro
doaj +1 more source
Applied Sciences, 2021 Power semiconductors based on wide bandgap (WBG) devices are capable of fast switching and have low on-resistance. Accordingly, a fast sensor with a higher bandwidth is required for circuit inspection based on switch current measurements.
Ui-Jin Kim
doaj +1 more source
Технічна інженерія, 2023 The article investigates mathematical modeling of the induction heating element (IHE) at the base of the thermo-anemometric flow meter (TAFM) for measuring the flow of diesel fuel (DF).
Y.O. , O.O.
doaj +1 more source
Effect of the Insulating Layer on the Properties of SMC Inductors
Applied Sciences, 2022 In inductor applications, different soft magnetic materials are used depending on the frequency range. Owing to powder metallurgy technology and to the increase in the implementation of innovative multifunctional materials, it is possible to find an ...
Emir Pošković +2 more
doaj +1 more source
Aluminium-oxide wires for superconducting high kinetic inductance circuits [PDF]
, 2016 We investigate thin films of conducting aluminium-oxide, also known as granular aluminium, as a material for superconducting high quality, high kinetic inductance circuits. The films are deposited by an optimised reactive DC magnetron sputter process and
Bushev, P. +9 more
core +2 more sources
Determination of Stray Inductance of Low-Inductive Laminated Planar Multiport Busbars Using Vector Synthesis Method [PDF]
, 2020 Laminated busbars connect capacitors with switching power modules, and they are designed to have low stray inductance to minimize electromagnetic interference. Attempts to accurately measure the stray inductance of these busbars have not been successful.
Hu, Junzhu +6 more
core +2 more sources
Design Equations for Class-E Power Amplifiers [PDF]
, 2006 In literature, it is widely accepted that the design of Class-E Power Amplifier (PA) with finite dc feed inductance requires a long iterative solution procedure. To avoid such iterative solution methods, analytical design equations should be known.
Acar, Mustafa +2 more
core +12 more sources
Square-wave drive for synchronous reluctance machine and its torque ripple analysis
CES Transactions on Electrical Machines and Systems, 2021 Synchronous reluctance machine (SynRM) can be perceived as a special type of permanent magnet synchronous machine (PMSM), and shares similar control method, i.e. the sine-wave current drive with sinusoidal phase currents. In this paper, square-wave drive,
Jian-Xin Shen +5 more
doaj +1 more source
The Journal of Engineering, 2019 An accurate computational model of transformer winding for potential distribution analysis under impulse voltage is very important for the design of transformer inter-turn insulation, especially for large capacity transformers such as ultrahigh-voltage ...
Shuang He +7 more
doaj +1 more source