Results 11 to 20 of about 13,584 (301)

‘Inductance’ definitions, modeling, and simulation [PDF]

open access: yes, 2021
The nonlinear behavior of the B-H relationship of a ferromagnetic material gives rise to two different types of permeabilities: ‘total permeability’ and ‘derivative permeability’. These are used in this study to define three inductances of a current dependent inductor that is built around a ferromagnetic core: ‘total inductance’, ‘derivative ...
Florian Hämmerle   +4 more
openaire   +1 more source

Systematic Design and Circuit Analysis of Lightning Impulse Voltage Generation on Low-Inductance Loads

open access: yesEnergies, 2021
The well-known circuit for the generation of lightning impulse voltage (LIV) on low-inductance loads was introduced by Glaninger in 1975, and the circuit component selection was proposed by Feser.
Peerawut Yutthagowith   +2 more
doaj   +1 more source

Bi-layer Kinetic Inductance Detectors for space observations between 80-120 GHz [PDF]

open access: yes, 2015
We have developed Lumped Element Kinetic Inductance Detectors (LEKID) sensitive in the frequency band from 80 to 120~GHz. In this work, we take advantage of the so-called proximity effect to reduce the superconducting gap of Aluminium, otherwise strongly
Benoit, A.   +12 more
core   +7 more sources

Simulation of inductive heating

open access: yesIEEE Transactions on Magnetics, 1992
Induction heating can be described by a heat transfer equation, where the heat is generated through ohmic losses from eddy currents induced by varying electromagnetic fields. In general tliis phenomenon will have to be described by two coupled equations, because most of the material properties are temperaturedependent ([3,4,14]).
Maten, ter, E.J.W., Melissen, J.B.M.
openaire   +2 more sources

Electronic Tunability and Cancellation of Serial Losses in Wire Coils

open access: yesSensors, 2022
This work presents a novel methodology to adjust the inductance of real coils (electronically) and to cancel out serial losses (up to tens or even hundreds of Ohms in practice) electronically.
Roman Sotner   +4 more
doaj   +1 more source

Emulating the one-dimensional Fermi-Hubbard model by a double chain of qubits [PDF]

open access: yes, 2016
The Jordan-Wigner transformation maps a one-dimensional (1D) spin- 1 / 2 system onto a fermionic model without spin degree of freedom. A double chain of quantum bits with X X and Z Z couplings of neighboring qubits along and between the ...
Braumüller, Jochen   +4 more
core   +1 more source

Improved Y-Source Single-Stage Transformerless Micro-Inverter for PV Residential Applications [PDF]

open access: yesEngineering and Technology Journal, 2020
Y-Source Impedance Network (YSN) is one of the most suitable for providing high voltage gain. It generatesa high voltage gain by using a small shoot-through duty cycle, which makes it suitable in applications require a wide range of input voltages such ...
Firas Salih, Oday Ahmed
doaj   +1 more source

A Detailed Model of a half bridge IGBT Power Module Based on the Analytical ‎Calculation and Measurement for EMC Study ‎ [PDF]

open access: yesJournal of Operation and Automation in Power Engineering, 2022
The parasitic parameters of an IGBT power module cause various problems, especially for electromagnetic compatibility (EMC) concerns. The high-variations in voltage and current produced by the inductances/capacitances near switches in the transient ...
J. Borsalani, A. Dastfan, J. Ghalibafan
doaj   +1 more source

Integrated through-silicon-via-based inductor design in buck converter for improved efficiency

open access: yesElectrical engineering & Electromechanics, 2023
Introduction. Through-silicon-via (TSV) is one of the most important components of 3D integrated circuits. Similar to two-dimensional circuits, the performance evaluation of 3D circuits depends on both the quality factor and inductance.
A. Namoune   +4 more
doaj   +1 more source

Design of millimeter-wave bandpass filters with broad bandwidth in Si-based technology [PDF]

open access: yes, 2019
In this paper, a novel design approach is proposed for on-chip bandpass filter (BPF) design with improved passband flatness and stopband suppression. The proposed approach simply uses a combination of meander-line structures with metal-insulator-metal ...
Sun, Feng   +5 more
core   +2 more sources

Home - About - Disclaimer - Privacy