Results 101 to 110 of about 162,004 (308)
A fluorine‐rich acrylate monomer (PFHEA) was solvent‐free applied to NCM90 and thermally decomposed under Ar to convert residual lithium into LiF and form a pre‐built LiF/fluorinated amorphous carbon (LiF/FC) interphase. The LiF/FC layer suppresses NiO rock‐salt reconstruction and microcrack propagation, lowers interfacial resistance, and improves Li ...
Pangyu Kim +6 more
wiley +1 more source
Feasibility study to use the current transformers as inductive partial discharge sensors
Partial discharge (PD) is the most important factor in gradual insulation deterioration of high‐voltage (HV) power equipment, and then PD trend monitoring is a great issue for their condition assessment. Impulsive high‐frequency PD current/voltage signals can be detected by using electrical sensors, e.g. inductive/capacitive sensors.
Farhad Haghjoo, Ali Savaei
openaire +1 more source
The dc-to-dc converters employing staggered-phase power switches with two-loop control [PDF]
A switched inductor voltage is coupled to a sense winding in each phase, and all sense windings are connected in series to one of two feedback loops to provide a signal that indicates when one of the power switches is on as the principal determinant of ...
Wester, G. W.
core +1 more source
Controlling the exposed crystal facet of shape‐controlled Au‐Pd core‐shell catalysts though colloidal synthesis enhances their catalytic performance in the industrially relevant selective hydrogenation of butadiene. ABSTRACT Selective hydrogenation of butadiene is a critical step in purification of alkene feedstocks for polymer production and is ...
Marta Perxés Perich +3 more
wiley +1 more source
We developed a novel magnetic coupling module formed of a monolayer superconducting flux concentrator, which is integrated with a coplanar resonator strongly coupled to HTS rf-SQUID. Three types of resonators, including a long stripline resonator between
Fardmanesh, Mehdi +3 more
core +1 more source
Understanding the Effects of Conductive Polymer Electrode Coating on Recorded Neural Signals
Conductive polymer coatings are widely explored to improve the quality of signals recorded with chronically implanted neural electrodes, offering enhanced biocompatibility along with reduced electrode impedance. Combining computational modelling and data from PEDOT:PTS coated and PtIr electrodes in rats, we show that improvements in signal quality with
Karthik Sridhar +4 more
wiley +1 more source
A novel inductive electromagnetic energy harvester for condition monitoring sensors [PDF]
As the operation of electrical power networks becomes increasingly sophisticated, the role of condition monitoring is expanding. The burden of implementing additional condition monitoring will be eased if self-powered, fully autonomous sensors can be ...
Fraser, Leigh +2 more
core
Implantable optoelectrical devices are an effective resource for the modulation and monitoring of neural activity with high spatiotemporal resolution. This review discusses current challenges faced by these devices and outlines future perspectives for the development of next‐generation neural interfaces targeting chronic, multisite, and multimodal ...
Stella Aslanoglou +4 more
wiley +1 more source
The Effect of Adding Series Capacitor and Phase Shifting Transformer on Power System Performance
Promoting power system performance is regarded as one of the essential issues for a sustainable customer service, alongside with the expansion of the inductive loads and population increase.
Mohammad A. Abdullah +1 more
doaj +3 more sources
Present status of development of damping ring extraction kicker system for CLIC
The CLIC damping rings will produce ultra-low emittance beam, with high bunch charge, necessary for the luminosity performance of the collider. To limit the beam emittance blow-up due to oscillations, the pulse power modulators for the damping ring ...
Barnes, Mike +4 more
core

