Results 11 to 20 of about 153,268 (299)
The Method to Determine the Turns Ratio Correction of the Inductive Current Transformer
Energies, 2021 This paper presents the method for evaluation of the turns ratio correction of the inductive current transformer using the magnetization curves determined at the non-load state and in the load conditions.
Ernest Stano
doaj +2 more sources
Amplification of S-1 Spheromak current by an inductive current transformer [PDF]
, 1985 We attempt to predict the consequences of adding an inductive current transformer (OH Transformer) to the present S-1 Spheromak experiment. Axisymmetric modeling with only classical dissipation shows an increase of toroidal current and a shrinking and hollowing of the current channel, conserving toroidal flux.
Jardin, S. C., Janos, A., Yamada, M.
openaire +3 more sources
Use of COMTRADE Fault Current Data to Test Inductive Current Transformers [PDF]
2019 II Workshop on Metrology for Industry 4.0 and IoT (MetroInd4.0&IoT), 2019 This paper presents a study on the inductive current transformer behaviour when subjected to distorted actual waveforms. Typical tools adopted to deal with such a condition, as the well-known ratio error, phase error, frequency response, etc. not always provide satisfactory results in all the possible operating condition. In addition, Standards lack in
Mingotti, Alessandro +3 more
openaire +3 more sources
New Approach to Evaluate the Transformation Accuracy of Inductive CTs for Distorted Current
Energies, 2023 This paper presents a newly developed method to determine the values of current error and phase displacement for the transformation of distorted current harmonics by the inductive current transformers.
Michal Kaczmarek, Ernest Stano
doaj +2 more sources
Estimation of the inductive current transformer derating for operation with distorted currents
Bulletin of the Polish Academy of Sciences Technical Sciences, 2014 Abstract The aim of the paper is to present a new method for estimation of the CT (Current Transformer) rated primary current and / or load of the secondary winding derating levels for transformation of distorted current in relation to the rated values fixed for transformation of sinusoidal current.
M. Kaczmarek
openaire +2 more sources
EnergiesNanocrystalline material provides an opportunity to improve the wideband performance of inductive current transformers and enables the possibility of ensuring their transformation accuracy for distorted and sinusoidal current from 50 Hz up to 20 kHz ...
Michal Kaczmarek
doaj +2 more sources
Sensors, 2020 The aim of this work is to assess whether actual distorted conditions of the network are really affecting the accuracy of inductive current transformers.
Alessandro Mingotti +4 more
doaj +2 more sources
EnergiesAccording to standards, the harmonic content should be less than 5% at the time of calibration, while the calibration index proposed in this paper stipulates that the primary current amplitude of 1%~120% of the full range of the accuracy level reaches 0 ...
Can Ding +3 more
doaj +2 more sources
Design of a Current-Transformer Based Inductive Coupler for Power-Line Communications
IEEE Transactions on Power Delivery, 2023 In this paper, the design of a current-transformer based inductive coupler for power-line communications is documented. A worst-case design is presented in a step-by-step fashion and experimentally confirmed by doing verification measurements in the ...
Petrus A. Janse Van Rensburg +2 more
openaire +2 more sources
IET Electric Power Applications, 2019 The increasing number of non‐linear loads and renewable energy sources causes a decrease in the power quality in the power networks. Therefore, tests of current transformers should be performed in similar conditions. This requires generation by a high current testing transformer of distorted currents that rms values are from a few hundred to several ...
Michal Lukasz Kaczmarek, Ernest Stano
openaire +2 more sources