Influence of the Size and Shape of Magnetic Core on Thermal Parameters of the Inductor
Energies, 2020 In this paper, a new thermal model of the inductor is proposed. This model takes into account self-heating in the core and in the winding, and mutual thermal couplings between the mentioned components of the inductor.
Kalina Detka, Krzysztof Górecki
doaj +1 more source
Power Losses Models for Magnetic Cores: A Review
Micromachines, 2022 In power electronics, magnetic components are fundamental, and, unfortunately, represent one of the greatest challenges for designers because they are some of the components that lead the opposition to miniaturization and the main source of losses (both ...
Daniela Rodriguez-Sotelo +5 more
doaj +1 more source
Substrate Engineering of Inductors on SOI for Improvement of Q-Factor and Application in LNA
IEEE Journal of the Electron Devices Society, 2020 High Q-factor inductors are critical in designing high performance RF/microwave circuits on SOI technology. Substrate losses is a key limiting factor when designing inductors with high Q-factors.
Arun Bhaskar +8 more
doaj +1 more source
Constant frequency, non‐isolated multichannel LED driver based on variable inductor
IET Circuits, Devices and Systems, 2021 To obtain the required LED‐driving current, variable frequency control directly leads to large reactive circulation, and the design of the electromagnetic interference circuit is more complex.
Guozhuang Liang +4 more
doaj +1 more source
CMOS X‐band pole‐converging triple‐cascode LNA with low‐noise and wideband performance
IET Circuits, Devices and Systems, 2022 A pole‐converging X‐band low‐noise amplifier (LNA) using 130 nm CMOS technology is proposed. An on‐chip pole‐converging capacitor CPC is added between the gate and drain node of the common‐gate (CG) stage. The capacitor CPC combines with a noise‐reducing
Cheng Cao +6 more
doaj +1 more source
Novel immense configurations of boost converter for renewable energy application
The Journal of Engineering, 2019 A three-immense configurations of boost converter for renewable energy application is presented here. The voltage lift switched inductor (VLSI) structure is pledged to extra high-voltage conversion.
Pandav Kiran Maroti +4 more
doaj +1 more source
High step-up interleaved boost converter utilising stacked half-bridge rectifier configuration
The Journal of Engineering, 2019 This paper proposes a solution to complement the insufficient voltage gain and voltage stress distribution of classical interleaved boost converter in high step-up application.
Musbahu Muhammad +3 more
doaj +1 more source
DC–DC converter with a high step-down ratio for water desalination applications
The Journal of Engineering, 2019 A single-stage 600 : 1 ratio voltage step-down dc–dc converter designed to produce a voltage of between 1 and 1.5 V from a rectified single/three-phase AC supply, for application in a desalination process, is presented. A coupled-inductor design is used,
Richard C. Pollock +3 more
doaj +1 more source
Modeling and Measurements of Properties of Coupled Inductors
Energies, 2021 This paper proposes a model of a coupled inductor which takes into account the influence of frequency, temperature, and a constant component, IDC, of currents in the windings on the parameters of the considered element.
Kalina Detka +3 more
doaj +1 more source
Design of Pulse Spiral Inductor Wound by Rectangular Cross-Section Wire
IEEE AccessAccording to the structural characteristics of the spiral inductor wound by rectangular cross-section wire, a calculation model of pulse spiral inductor was established. A design method of pulse spiral inductor was presented, which takes inductance value,
Shuangpeng Hao +3 more
doaj +1 more source