Results 91 to 100 of about 32,444 (303)
eXPRESS Polymer Letters, 2019 In this paper, a kind of polypropylene (PP) foam plastic parts with special weld lines were obtained by core-back foam injection molding with chemical blowing agent. A new kind of weld line was found and its formation process was proposed.
H. Wu +4 more
doaj +1 more source
Advanced Functional Materials, EarlyView.We introduce a capillary‐filtering‐based particle‐filling (CFPF) process that simultaneously forms vertical thermal pathways and electrical vias within µ‐pores. In situ microfluidic analysis reveals that capillary‐driven velocity gradients generate vorticity that governs µ‐platelet rotation and vertical alignment.
Yujin Mun +11 more
wiley +1 more source
Powder co-injection moulding [PDF]
, 2000 A novel powder processing technique has been developed by combining conventional powder injection moulding with polymer co-injection moulding, to permit the in-situ surface engineering of metal or ceramic components as an integral step within the ...
Hanson, S. M. J.
core
Flatness optimization of micro-injection moulded parts: the case of a PMMA microfluidic component [PDF]
, 2011 Micro-injection moulding (µ-IM) has attracted a lot of interest because of its potential for the production of low-cost, miniaturized parts in high-volume.
Alcock, Jeffrey R. +17 more
core +1 more source
Anomaly detection of the injection molding clamping unit
Nihon Kikai Gakkai ronbunshu, 2019 Our previous research (Naganuma, Hashimoto, 2018) demonstrates that the anomaly detection in the injection molding clamping unit will be made possible by evaluating the operating mode.
Tsuneo NAGANUMA, Koichi HASHIMOTO
doaj +1 more source
Advanced Healthcare Materials, EarlyView.Coagulative granular hydrogels are composed of packed thrombin‐functionalized microgels that catalyze the conversion of fibrinogen into a secondary fibrin network, filling the interstitial voids. This bio‐inspired approach stabilizes the biomaterial to match the robustness of bulk hydrogels without compromising injectability, mimicking the initial ...
Zhipeng Deng +16 more
wiley +1 more source
Micro-Injection Moulding Of Three-Dimensional Integrated Microfluidic Devices [PDF]
, 2009 This thesis investigates the use of micro-injection moulding (μIM), as a high-volume process, for producing three-dimensional, integrated microfluidic devices.
Attia, Usama M.
core
A Novel Decellularized Fibrocartilage Graft Promotes Tympanic Membrane Repair
Advanced Healthcare Materials, EarlyView.An off‐the‐shelf decellularized porcine meniscus fibrocartilage graft (MEND) is engineered for pediatric tympanoplasty. Featuring a microchannel architecture that promotes host cell invasion, MEND rapidly closes tympanic membrane perforations and fully remodels in vivo, outperforming fascia and matching cartilage grafts while avoiding donor‐site ...
Paul M. Gehret +6 more
wiley +1 more source
Characterization of shrinkage effects in micro-injection moulding (µ-IM) [PDF]
, 2013 This thesis characterizes the effects on shrinkage in microinjection moulding. The literature review considers four branches of investigation (material properties, processing parameters, mould design and specimen design).
Annicchiarico, Daniele
core