Results 1 to 10 of about 7,418,041 (222)
BLOCKING ALGORITHM FOR CURRENT PROTECTION DURING INRUSH MAGNETIZATION CURRENT [PDF]
The paper presents blocking algorithm for current protection during inrush process. The algorithm is based on the evaluation of the ratio of the positive sequence second harmonic current to the negative sequence first harmonic current.
F. A. Romaniuk, M. S. Loman
doaj +2 more sources
Calculating the Inrush Current of Superconducting Transformers [PDF]
Under certain circumstances, after connecting a superconducting transformer to the power network, a high value current may flow through its windings. This current can exceed the critical value of the superconductor many times and cause the windings to ...
Grzegorz Komarzyniec
doaj +2 more sources
AN ASPECT OF TRANSFORMER INRUSH CURRENT
Paper analyzes a sparking phenomena that were observed on power transformers during their first few energizing. Sparks occurred on the flange between tank cover and tank side, in spite of the fact that a jumper (copper link) was used. The phenomenon was observed on transformers from different manufacturers, with various transformer ratings, three or ...
Mikulecky, Antun +2 more
openaire +5 more sources
Damping the Inrush Current for Current Transformer [PDF]
The inrush current is a highly asymmetric transient magnetizing current resulting from saturation of the core of the transformer caused by excessive growth of magnetic flux in one direction only. The suggested strategy to damp the inrush current is adding an inductor in parallel with the circuit breaker (C.B., which has a very low resistance when it is
Yousif Alyounus +2 more
openaire +1 more source
A REVIEW ON MAGNETIZING INRUSH CURRENT. [PDF]
Magnetizinginrush current is a current which occurs in transformer during switchingon..The main objective is to examine the cause and effects of magnetizing inrush current on transformer. The paper also suggests measures to remedy dangers posed by magnetizing inrush current in transformers.
Asad Zai +2 more
openaire +3 more sources
When an electromagnetic transient occurs in a transformer, certain parts of the winding will be over stressed internally, which in severe cases will lead to the destruction of the winding insulation.
Chenchen Zhang +3 more
doaj +1 more source
Pre-energize Analysis on 3 Phase Transformer by Considering Each Phase Flux
Inrush current is a transient phenomenon that occurs when a transformer is first energized to a voltage source at no-load conditions. It causes a very high inrush current.
Hadwim Septiawan
doaj +1 more source
In recent years, the zero-mode inrush current of high-impedance transformer with built-in high-voltage winding (T-Hin), which has large amplitude and decays slowly, causes the misoperation of zero-sequence overcurrent protection.
Wenbin Cao +5 more
doaj +1 more source
When the electromagnetic transients occur in a power transformer, an inrush current is generated in its winding. The inrush current not only affects the performance of the transformer windings, but also affects the lifetime of the transformer.
Wenqi Ge +4 more
doaj +1 more source
This paper proposes the inrush current suppressor using an AC chopper in a large-capacity wind power generation system (WPGS) with two squirrel-cage induction machines (SCIMs), which are switched over depending on the wind speed. The input side of the AC
Sho Shibata +3 more
doaj +1 more source

