Results 21 to 30 of about 7,418,041 (222)

Voltage compensation-type inrush current limiter for reducing power transformer inrush current

open access: yesIET Electric Power Applications, 2012
When a transformer is initially energised, its iron core is driven into saturation, which will result in high-amplitude magnetising inrush current. For lessening this transient phenomenon, a voltage compensation-type inrush current limiter (VCT-ICL) is presented in this study.
H.-T. Tseng, J.-F. Chen
openaire   +1 more source

INRUSH CURRENT OF LAMP

open access: yes, 2021
Lighting systems pass through big change in terms of light source recently. LED replace discharge lamp and thischange represent change of electrical parameters and influence to installations.
Mokráň, Marek, Janiga, Peter
core   +1 more source

Inrush Current Management During Medium Voltage Microgrid Black Start With Battery Energy Storage System

open access: yesIEEE Access, 2022
This paper addresses the black start of medium voltage distribution networks (MV-DNs) by a battery energy storage system (BESS). The BESS consists of a two-level voltage source inverter interfacing MV-DN which has limited overcurrent capability.
Mahdi Shahparasti   +5 more
doaj   +1 more source

A New method for winding connected to the ground internal fault localization in the transformer using the extended Kalman Filter

open access: yesFranklin Open
Inrush current in the transformer may assume as fault current for the protective equipment. Thus, it is important to distinguish the inrush current from the internal fault current in the transformer.
Mohammad Ali Taghikhani   +1 more
doaj   +1 more source

Commutation failure suppression strategy of hybrid DC transmission based on active current limiting

open access: yes电力工程技术, 2022
Aiming at the problem of large inrush current when the commutation fails in the hybrid direct current (DC) transmission system,the relationship between the inrush current amplitude and the voltage source converter (VSC) is firstly derived.
MA Wenzhong   +5 more
doaj   +1 more source

Application of saturated core transformer as inrush current limiter

open access: yese-Prime: Advances in Electrical Engineering, Electronics and Energy
An inrush current is a transient current that results from a sudden change in the exciting voltage across a transformer's windings. Reducing the inrush current of transformers is desirable due to mechanical stresses and negligent operation of protective ...
Mehrdad Tarafdar-Hagh   +5 more
doaj   +1 more source

Dynamic geo‐hydrogeological monitoring‐driven situational awareness for real‐time floor water inrush risk prediction in deep mining

open access: yesDeep Underground Science and Engineering, EarlyView.
The fused data extracted from the distributed monitoring system as the data basis, combined with dynamic geological data, are imported into a deep learning model. As the geological conditions of mining and excavation change, the risk of water inrush at the working face is retrieved in real time.
Yongjie Li   +4 more
wiley   +1 more source

CALCULATION OF MAGNETIZING INRUSH CURRENT IN TRANSFORMER

open access: yes, 2021
When transformer is energized its current reaches very high value generally approximately 10 to 20 times greater than its rated current. This paper deals with study of calculation of inrush current in transformer.
DR.N.M.LOKHANDE   +2 more
core  

Reduced-Capacity Inrush Current Suppressor Using a Matrix Converter in a Wind Power Generation System with Squirrel-Cage Induction Machines

open access: yesEnergies, 2016
This paper describes the reduced capacity of the inrush current suppressor using a matrix converter (MC) in a large-capacity wind power generation system (WPGS) with two squirrel-cage induction machines (SCIMs). These SCIMs are switched over depending on
Sho Shibata   +3 more
doaj   +1 more source

Upper bound limit analysis of coral reef limestone cavern roof stability incorporating a tension‐shear failure mechanism with tensile‐strength cut‐off

open access: yesDeep Underground Science and Engineering, EarlyView.
For the roof of coral reef limestone caverns, a novel tension‐shear composite failure mechanism was developed. The most critical tensile crack model was identified using a hybrid optimization algorithm, and the stability of the cavern roof was analyzed accordingly.
Dongsheng Xu, Chenxu Li, Chuantan Hou
wiley   +1 more source

Home - About - Disclaimer - Privacy