Results 1 to 10 of about 5,713 (121)
Mechanical Behavior of Fe- and Co-Based Amorphous Alloys after Thermal Action
Metals, 2022 The effect of heat treatment on the structure and mechanical properties of Co-Fe-Cr-Si-B/Fe-Cr-B/Fe-Ni-B amorphous alloys has been studied systematically. Melt-quenching (spinning method) was used for production of investigated amorphous alloys.
Inga Permyakova, Alex Glezer
doaj +1 more source
Biological Toxicity of Heavy Metal(loid)s in Natural Environments: From Microbes to Humans
Frontiers in Environmental Science, 2022 Excessive levels of heavy metal(loid)s (HMs) in natural environments pose a serious threat to living beings worldwide. HM exposure causes irreversible damage to structural components and metabolic processes in living organisms, as has been observed in ...
Chunlian Ding +10 more
doaj +1 more source
Amorphous-Nanocrystalline Composites Prepared by High-Pressure Torsion
Metals, 2020 This article presents systematic studies of the preparation method and the specific features of the changes in the structure and properties of amorphous-nanocrystalline composites formed from melt-quenched ribbons of iron- and cobalt-based amorphous ...
Inga Permyakova, Alex Glezer
doaj +1 more source
Data in Brief, 2021 In this paper, we presented the dataset values of full width at half maximum (FWHM) with errors at each point corresponding to the value of longitudinal and transverse residual stress along the three lines for 14 points measured in the EBW welded joints (
Raghawendra P.S. Sisodia +3 more
doaj +1 more source
Studia Historiae Scientiarum, 2019 Several remarks on the text by Mariusz W. Majewski devoted to the history of the Institute of Metallurgy and Metal Science at the Technical University of Warsaw, and on the role of Prof. Jan Czochralski, are presented.
Paweł E. Tomaszewski
doaj +1 more source
Data on measurement of the strain partitioning in a multiphase Zn-Al eutectic alloy
Data in Brief, 2018 This paper presents original data related to the research article “Local mechanical properties and plasticity mechanisms in a Zn-Al eutectic alloy” (Wu et al., 2018).
Zhicheng Wu +5 more
doaj +1 more source
Investigation of Multicomponent Lead-Free Solders
Archives of Metallurgy and Materials, 2017 According to the directives (RoHS and WEEE) adopted by the European Union, lead has been banned from the manufacturing processes because of its health and environmental hazards. Therefore, the development of lead-free solders is one of the most important
Gyenes A. +4 more
doaj +1 more source
Whisker Formation On Galvanic Tin Surface Layer
Archives of Metallurgy and Materials, 2015 The present work reports the effect of substrate composition, thickness of the tin electroplate and its morphology on pressure-induced tin whisker formation.
Radanyi A.L., Sycheva A., Gacsi Z.
doaj +1 more source
Journal of Materials Research and Technology, 2020 Ultrasonic-assisted twin-roll casting (UA-TRC) process was developed for the production of high quality 1050 aluminum alloy strip with minimum casting defects.
Jinxian Huang +4 more
doaj +1 more source
Studia Historiae Scientiarum, 2019 The article is a response to the polemical commentary by Paweł E. Tomaszewski, PhD, published in the current volume of the journal Studia Historiae Scientiarum 18 (2019), regarding the author’s earlier article on the work of the Institute of Metallurgy ...
Mariusz W. Majewski
doaj +1 more source