Results 11 to 20 of about 8,720 (138)
Powder co-injection moulding [PDF]
, 2000 A novel powder processing technique has been developed by combining conventional powder injection moulding with polymer co-injection moulding, to permit the in-situ surface engineering of metal or ceramic components as an integral step within the ...
Hanson, S. M. J.
core +7 more sources
The effect of steam treatment and precipitation hardening on the mechanical properties and wear resistance of sintered iron and iron-copper alloys [PDF]
, 1980 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.Steam treatments reduce porosity(1) of sintered iron and sintered iron-base alloy products and provide them with increased compressive strength, hardness,
Razavizadeh, Kamaladin
core +7 more sources
Selective Laser Sintering of a Stainless Steel Powder [PDF]
, 2003 The research presented in this thesis was part of a larger collaborated project (LastForm Programme) to research engineering solutions for the rapid manufacture of large scale (0.5m – 5.0m in length) low, medium and high temperature tooling (from room ...
Hauser, Carl
core +6 more sources
Assessment of wear resistance of tin and tin alloy coatings [PDF]
, 2007 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.Tin alloy coatings have traditionally been used as corrosion resistant bamens due to their inert nature and comprehensive coverage, and have seldom been ...
Lam, Wayne Pui-Wing
core +7 more sources
Investigation of the hot deformation of sintered titanium compacts produced from direct reduction powder [PDF]
, 2010 Includes bibliographical references (leaves 110-111).The focus of this study was the use of powder metallurgy to produce low cost titanium with comparative mechanical properties to wrought titanium.
Petersen, Shaheeda
core +1 more source
International Journal of Electrochemical Science, 2011 The electrochemical behavior of the V(IV)/V(V) couple in an aqueous solution of 2 mol dm-3 H2SO4+2 mol dm-3 VOSO4 on a graphite electrode at different temperatures is studied by steady-state polarization and electrochemical impedance spectroscopy.
Liu Hui-jun +4 more
doaj +1 more source
Crystals, 2022 During the solidification of hypoeutectic Al–7% Si alloy, density differences develop in the melt due to variations in concentration and temperature. On Earth, melt flow can occur due to gravity, which then affects the solidification process.
András Roósz +7 more
doaj +1 more source
Crystals, 2022 During ground-based solidification, buoyancy flow can develop by the density difference in the hypoeutectic type of the alloys, such as Al-7 wt% Si alloy.
András Roósz +7 more
doaj +1 more source
Factors Affecting the Mechanical Performance of High Manganese Austenitic Steel
Metals, 2022 High manganese austenitic steel has attracted increasing attention for its application in liquefied natural gas storage tank materials due to its excellent ductility and low cost. This paper presents an overview of the research progress of high manganese
Lei Xia +5 more
doaj +1 more source
The effect of deformation temperature on recrystallization in a Ni-based single crystal superalloys
Materials & Design, 2022 A series of experiments have been carried out to investigate the effect of deformation temperature on the recrystallization of nickel-based single crystal superalloys using isothermal (compression) and non-isothermal (directional solidification ...
Wei Xiong +8 more
doaj +1 more source