Results 41 to 50 of about 1,218 (181)
Nitrogen/sulfur co‐doping optimizes the electron and spatial structure of biomass‐derived hard carbon, and the anode demonstrates superior long‐term cycling stability over 2000 cycles, validating an improved “adsorption‐intercalation‐pore filling” mechanism.
Qian Long +8 more
wiley +1 more source
Micro-Alloying and Phase Transformation Control of Steel 82B and Production Practice
In order to optimize composition and hot-rolling cooling process of 82B to improve strength of 82B wire rod, the influence of isothermal transformation temperature of steel 80 and steel 82B on phase transformation time and pearlite interlamellar spacing ...
韦轶华 +5 more
doaj
Effect of heat treatment on the microstructure and mechanical properties of TiAl alloys
In this work, a Ti45Al45Nb5Mo5 alloy was prepared by non-self-consuming vacuum arc melting furnace. The effects of heat treatment on the microstructure and mechanical properties of the alloys were investigated.
Bo Li +8 more
doaj +1 more source
Influence of Microstructure on Strength and Ductility in Fully Pearlitic Steels
This article deals with the relationship between the microstructure and both strength and ductility in eutectoid pearlitic steel. It is seen how standard mechanical properties and fracture micromechanisms are affected by heat treatment and the resulting ...
Jesús Toribio +3 more
doaj +1 more source
Thermokinetic processing controls graphene fragmentation and dispersion in HDPE, promoting heterogeneous nucleation and multistep crystallization. The balance between nucleation enhancement and chain mobility restriction governs the final crystalline structure and material performance.
Lucas J. S. Nascimento +4 more
wiley +1 more source
Acid Resistant and Highly Silver Selective Membranes Based on Charged Nanoporous 2D‐Materials
In this work, new membranes based on charged & nanoporous nanosheets with unprecedented selectivity to silver versus a wide range of other metallic ions are reported. Furthermore, a demonstrated and lead specific intralamellar lead pathway is demonstrated. A potential applicability for ubiquitous silver in WEEE is validated.
Sarah M. Chevrier +6 more
wiley +1 more source
Influence of Rolling Deformation on Interlamellar Spacing of Pearlite in U75V Heavy Rail Steel
The cast bloom size for U75V heavy rail steel is 280 mm×380 mm,and the heavy rail products are produced with 14 passes rough rolling(BD1)- medium rolling(BD2)and CCS 6 passes finishing rolling(UR1ER,UR2UR3EF,UF).The interlamellar
王晓丽, 宋波, 焦国利
doaj
The phase transformation behavior of a hypoeutectoid steel is studied in comparison with alloys containing higher concentrations of tramp elements, simulating high recycling rates. The examination of microstructures reveals that the tramp elements facilitate the formation of displacive phases along with retained austenite.
Lukas Hatzenbichler +7 more
wiley +1 more source
N2 and CO2 Adsorption by TMA- and HDP-Montmorillonites
N2 and CO2 gases adsorption by tetramethylammonium(TMA)-montmorillonites and hexadecylpyridinium(HDP)-montmorillonites was carried out using volumetric equipment at 25 °C and 0.1 MPa.
C. Volzone, J. O. Rinaldi, J. Ortiga
doaj +1 more source
Experimental research on the effect of induction reheating on the microstructure and mechanical properties of hot-rolled low-alloy steel plate [PDF]
Electric induction reheating is used to control the temperature of hot-rolled steel products. To investigate the effect of this on microstructure and mechanical properties, hot-rolled low-alloy steel plate was cooled, reheated, and then either quenched ...
Zejun Chen +3 more
doaj +1 more source

