Results 61 to 70 of about 225,515 (313)
Dynamic Precipitation during High‐Pressure Torsion of a Magnesium–Manganese Alloy
An ultrafine‐grained alloy is produced by high‐pressure torsion of solutionized Mg–1.35 wt% Mn. Precipitation of nanometer‐scale Mn particles during deformation provides pinning sites. This prevents the formation of a bimodal grain structure and results in a finer grain size than for pure Mg.
Julian M. Rosalie, Anton Hohenwarter
wiley +1 more source
This article describes the preparation and characterization of poly(ε‐caprolactone) electrospun composite fibers incorporating sol‐gel‐derived bioactive glass particles doped with B and Cu. Scanning electron microscopy, energy‐dispersive X‐ray spectroscopy, Fourier‐transform infrared spectroscopy, contact angle, acellular bioactivity, mechanical and ...
Elisa Piatti +5 more
wiley +1 more source
Freeze‐drying of layered silicate is the key to get coatings with superior gas barrier. Freeze‐drying of layered silicates modified with dodecylamine (DDA) is a highly effective technique for the preparation of barrier pigments that significantly mitigate the permeation of oxygen, water vapor, and hydrogen through polymer films containing these ...
Joshua Lommes +4 more
wiley +1 more source
Liquid-liquid extraction is an alternative method that can be used for desulfurization and denitrification of gasoline and diesel fuels. Recent approaches employ different ionic liquids as selective solvents, due to their general immiscibility with ...
Beata Gabrić +3 more
doaj +1 more source
New insights into the air gap conditioning effects during the dry-jet wet spinning of an ionic liquid-cellulose solution [PDF]
Chamseddine Guizani +5 more
openalex +1 more source
Al‐Cu intermetallic compounds (IMCs) have a significant influence on the properties of Al‐Cu bimetallic interfaces formed in compound casting. This article provides a deeper understanding of microstructure, crystallography, thermal properties, hardness, and corrosion response of Al‐Cu IMCs with the goal of facilitating the optimization of the ...
Alireza Nazarahari +7 more
wiley +1 more source
Robot‐Assisted Automated Serial‐Sectioning and Imaging for 3D Microstructural Investigations
A fully automated 3D microstructure characterization platform provides new insights into materials. This robot‐assisted system performs serial‐sectioning, etching, and optical imaging to generate large‐volume 3D reconstructions with submicron resolution.
Michael Moschetti +7 more
wiley +1 more source
The cellulase production by P. janthinellum mutants on lignocellulosic material such as cellulose or steam exploded bagasse (SEB) in combination with wheat bran was studied in solid state fermentation (SSF).
Mukund G. Adsul +3 more
doaj
Towards Biohydrogen Separation Using Poly(Ionic Liquid)/Ionic Liquid Composite Membranes
Considering the high potential of hydrogen (H2) as a clean energy carrier, the implementation of high performance and cost-effective biohydrogen (bioH2) purification techniques is of vital importance, particularly in fuel cell applications.
Andreia S. L. Gouveia +3 more
doaj +1 more source

