Results 81 to 90 of about 235,275 (302)
Separation of silicon-iron-copper-nickel concentrate by fluorammonium method into individual oxides [PDF]
, 2007 Processes of ammonium hydrodifluoride interaction with main components of copper-nickel concentrates - iron, copper, nickel oxides have been investigated. Thermodynamics of chemical reactions was calculated.
Dyachenko, Alexander Nikolaevich +1 more
core
Low Temperature Oxidation of pure Iron : Growth kinetics and scale Morphologies [PDF]
, 2004 Isothermal oxidation of pure iron has been performed in air at atmospheric pressure between 260°C and 500°C. Growth kinetics are accurately analysed and scale morphologies are investigated by SEM and TEM observations. The calculation of the variations of
Bertrand, Nathalie +4 more
core +1 more source
Advanced Engineering Materials, Volume 27, Issue 6, March 2025.ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur +5 more
wiley +1 more source
Insights into secondary reactions occurring during atmospheric ablation of micrometeoroids [PDF]
, 2016 Ablation of micrometeoroids during atmospheric entry yields volatile gases such as water, carbon dioxide, and sulfur dioxide, capable of altering atmospheric chemistry and hence the climate and habitability of the planetary surface.
Court, RW, Tan, J
core +1 more source
پژوهشهای زراعی ایران, 2011 A greenhouse study was conducted to compare the effects of ordinary iron oxide (0.02-0.06 mm) and nano iron oxide (25-250 nm) and five levels of both iron oxides (0, 0.05, 0.1, 0.5, and 1.0 %w/w) and two levels of sulfurous granular compost (MSW) (0 and ...
S Mazaherinia +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Synthetic and natural iron oxide characterization through microparticle voltammetry [PDF]
, 2009 Se presentan los resultados de un estudio sobre el uso de la Voltametría de Micropartículas (VMP), aplicada a la identificación de óxidos y oxihidróxidos de hierro. Mediante esta técnica, fue posible diferenciar hematita, goethita, magnetita y maghemita,
Bidegain, Juan Carlos +2 more
core +3 more sources
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
X-ray photoelectron spectroscopy study of radiofrequency-sputtered refractory compound steel interfaces [PDF]
Radiofrequency sputtering was used to deposit Mo2C, Mo2B5, and MoSi2 coatings on 440C steel substrates. Both sputter etched and preoxidized substrates were used, and the films were deposited with and without a substrate bias of -300 V. The composition of
Brainard, W. A., Wheeler, D. R.
core +1 more source
The association of cobalt with iron and manganese (oxyhydr)oxides in marine sediment. [PDF]
, 2010 Formation and dissolution of authigenic Fe and Mn (oxyhydr)oxides influence cycling of trace metals in oxic/suboxic surface sediments.We used the diffusive gradients in thin films technique (DGT) to estimate the association of cobalt with iron and ...
Davison, William +3 more
core +1 more source