Results 51 to 60 of about 701 (180)

Model for Wall Shear Stress from Obliquely Impinging Planar Underexpanded Jets

Applied Sciences, 2022
Though inclined under-expanded planar jets are used in many practical applications, the wall stress resulting from their impingement has not been adequately characterized.
Patrick Fillingham, Arjun Viswanathan, Igor V. Novosselov   +2 more
doaj   +1 more source

A Detailed Review of Colburn and Friction Factors for Various Types of Fins Used in Compact Plate‐Fin Heat Exchangers

Heat Transfer, Volume 55, Issue 6, Page 3495-3522, September 2026.
ABSTRACT Compact plate‐fin heat exchangers (PFHEs) are commonly utilized in diverse industries, including aerospace, automotive, processing, and space. Various fin configurations, such as Plain fins, Wavy fins, Lance and Offset fins (OSFs), Perforated fins, louvered fins, and pin fins, are employed in compact heat exchangers (CHEs).
Chennu Ranganayakulu
wiley   +1 more source

Elephant‐Skin‐Inspired Porous Cementitious Tiles with Programmable Crack Networks for Passive Cooling

Advanced Materials, Volume 38, Issue 44, 7 August 2026.
Elephant‐skin‐inspired crack networks are programmed in porous diatomaceous earth (DE)‐cement composites using substrate‐guided, stress‐concentration induced fracture. The resulting crack lattices act as capillary conduits that redistribute water, while the porous matrix stores moisture.
Qingya Huang, Kun‐Hao Yu, Ji Yoon Bae, Yunchan Lee, Dorit Aviv, Shu Yang   +5 more
wiley   +1 more source

An Ultra‐Reliable and Highly Sensitive Flexible Piezoelectric Pressure Sensor Based on Vertically Aligned Gallium Nitride Microrod Arrays on Graphene

Advanced Materials Interfaces, Volume 13, Issue 15, 4 August 2026.
A flexible and highly reliable piezoelectric pressure sensor based on GaN p–n homojunction microrod arrays on graphene is demonstrated. The sensor exhibits high sensitivity, rapid response, excellent cyclic durability, and stable performance after thermal aging and PBS immersion, highlighting its potential for harsh‐environment and biomedical pressure ...
Asad Ali, Han Ik Kim, Seokje Lee, Imhwan Kim, Hongseok Oh, Gyu‐Chul Yi   +5 more
wiley   +1 more source

Engineering Strategies to Suppress Thermal Runaway Propagation in Lithium‐Ion Battery: Mechanisms, Metrics, Materials, and Evaluation Methods

Advanced Science, Volume 13, Issue 44, 7 August 2026.
Thermal runaway propagation can transform a single‐cell failure into a system‐level hazard in lithium‐ion battery packs. This review clarifies how heat transfer, gas venting, combustion, and configuration govern cell‐to‐cell failure, and links measurable metrics, pathway‐oriented suppression materials, and experimental/modeling tools to guide safer ...
Jinrong Su, Anna DiFelice, Jayani Mawela, Jianing Gan, Shuai Che, Wonhee Cho, Hanghang Yan, Yaohong Xiao, Xinxin Yao, Xiangwei Guo, Rui Wang, Dingchuan Xue, Hanlong Liu, Solomon Adera, Zhan Chen, Lei Chen   +15 more
wiley   +1 more source

Ag‐Assisted Interfacial Assembly of 2D/0D/2D Ti3C2Tx/Ag@g‐C3N4 Films With Synergistic Electromagnetic Interference Shielding and Thermal Management

EcoMat, Volume 8, Issue 8, August 2026.
Lightweight 2D/0D/2D Ti3C2Tx/Ag@g‐C3N4 composite films are fabricated via an Ag‐assisted self‐assembly strategy to construct abundant heterogeneous interfaces. Benefiting from a continuous conductive network and Ag‐bridged interfaces, the films exhibit high EMI shielding effectiveness, low infrared emissivity, and rapid low‐voltage Joule heating.
Baosong Li, Xuan Li, Shoaib Anwer, Abdallah Kamal, Dawei Zhang, Yarjan Abudul Samad, Kin Liao   +6 more
wiley   +1 more source

Comparative Performance Analysis of Various Flat Plate Solar Collectors Incorporating Spiral and Square Arrangement of Circular Type Riser Tube

Energy Science &Engineering, Volume 14, Issue 8, Page 3828-3847, August 2026.
Three flat‐plate collectors with spiral and square coiled riser tubes were tested and it was found that the spiral type provides the best results with a thermal efficiency of 66.98% for a mass flow rate of 0.4 kg/min. Riser tube geometry is a key factor in optimizing flat‐plate collector output.
Sakhail Islam Biaz, Golam Sharoar Fahim, Md Akib Ul Islam, Nahyan Ahnaf Pratik, Md. Hasan Ali   +4 more
wiley   +1 more source

Reconstructing Europa's Atmosphere From H2+ ${\mathbf{H}}_{\mathbf{2}}^{+}$ Pickup Ions Detected During the Juno PJ45 Flyby

Journal of Geophysical Research: Planets, Volume 131, Issue 8, August 2026.
Abstract We use a suite of single‐species (H2 ${\mathrm{H}}_{2}$) and multispecies (H2+O2+H+O ${\mathrm{H}}_{2}+{\mathrm{O}}_{2}+\mathrm{H}+\mathrm{O}$) Direct Simulation Monte Carlo models of Europa's atmosphere to interpret the H2+ ${\mathrm{H}}_{2}^{+}$ pickup ions detected by Juno at distances beyond 2 $2$ Europa radii RE $\left({R}_{E}\right ...
Shane R. Carberry Mogan, Andrew R. Poppe, Lucas Liuzzo, Jamey R. Szalay, Sean P. Ellis, Robert E. Johnson, Lorenz Roth   +6 more
wiley   +1 more source

Assessing the Underwater Impact of Aerodynamic Noise From Offshore Wind Turbines

Wind Energy, Volume 29, Issue 7, July 2026.
ABSTRACT The growing demand for offshore wind energy has led to a significant increase in wind turbine size and to the development of large‐scale wind farms, often comprising 100–150 turbines. However, the environmental impact of underwater noise emissions remains largely unaddressed.
Laura Botero‐Bolívar, Oscar A. Marino Sánchez, Martín de Frutos, Esteban Ferrer   +3 more
wiley   +1 more source

Conjugate Heat Transfer and Thermal Stress Analysis of a Gas Turbine Double-Wall Cooling System with a Diamond-Type TPMS Effusion

Energies
This research numerically investigates the cooling performance of Diamond-type triply periodic minimal surface (TPMS) networks as a gas turbine effusion cooling layer, augmented with various jet impingement configurations. The study analyzes the internal
Kirttayoth Yeranee, Chao Xu, Yuli Cheng, Yu Rao   +3 more
doaj   +1 more source