Results 171 to 180 of about 22,020 (188)
Some of the next articles are maybe not open access.
Preparation of Kenaf Bast Fibre Dispersions for Use in Latex Products
Journal of Rubber Research, 2018The use of kenaf has been extensively explored since its introduction in 1999 by the Malaysian government. However, its lacking application in rubber latex motivates the present study on preparation of kenaf bast fibre dispersions for the latex based industry.
Manroshan Singh +2 more
openaire +1 more source
Physicochemical characterization of different treatment sequences on kenaf bast fiber
Carbohydrate Polymers, 2006Abstract Three different processing sequences for pulping kenaf (Hibiscus cannabinus L.) bast fibers were investigated, and the chemical composition (cellulose, hemicellulose and lignin content) and physical properties (viscosity, degree of polymerization and crystallinity index) of the extracted pulp were determined.
Sherif Keshk +2 more
openaire +1 more source
Materials Science Forum, 2015
Kenaf bast fiber reinforced unsaturated polyester composite was produced using kenaf bast fiber based on different retting process. There are two different retting method involved which are water and mechanical retting process. The composites were prepared by using hand lay-up method with different fiber loading (weight %) of 10, 15 and 20%.
Abdul Rahman Rozyanty +3 more
openaire +1 more source
Kenaf bast fiber reinforced unsaturated polyester composite was produced using kenaf bast fiber based on different retting process. There are two different retting method involved which are water and mechanical retting process. The composites were prepared by using hand lay-up method with different fiber loading (weight %) of 10, 15 and 20%.
Abdul Rahman Rozyanty +3 more
openaire +1 more source
Performance characteristics of treated kenaf bast fibre reinforced cement composite
Journal of the Indian Academy of Wood Science, 2016This study investigated the effect of pretreatment on the properties of kenaf fibre cement boards. Homogenous fibre cement boards were made from kenaf bast fibres, cement and water. The fibres were cut into smaller sizes, mixed with cement and water and formed in rectangular moulds. After demoulding, the boards were cured for 28 days.
S. O. Amiandamhen +2 more
openaire +1 more source
Effect of partial delignification of kenaf bast fibers for radiation graft copolymerization
Journal of Applied Polymer Science, 2012AbstractMalaysian kenaf bast fiber was treated by acidic chlorite to be applied for a trunk polymer radiation‐induced graft copolymerization. The delignification conditions such as temperature, reaction time, and sodium chlorite (NaClO2) loading were optimized from the viewpoints of density, tensile strength, and reactivity of grafting.
Nor Hasimah Mohamed +3 more
openaire +1 more source
A green degumming approach for lignocellulosic kenaf bast using ethanolamine deep eutectic solvent
International Journal of Biological MacromoleculesTraditional chemical degumming methods for lignocellulosic bast fibers pose substantial challenges, especially when dealing with kenaf bast, which has a high lignin content. These challenges include severe pollution and low efficiency, etc. Therefore, this study developed a novel, green, and efficient degumming approach for lignocellulosic kenaf bast ...
Yan, Song +11 more
openaire +2 more sources
Bast fibres (flax, hemp, jute, ramie, kenaf, abaca)
2005R. Kozlowski +2 more
openaire +1 more source