Results 51 to 60 of about 329,633 (198)
Black Phosphorus Q-Switched Large-Mode-Area Tm-Doped Fiber Laser
International Journal of Optics, 2018 We report on a passively Q-switched fiber laser with black phosphorus as saturable absorber. By employing the sol-gel fabricated large-mode-area Tm-doped fiber as gain medium, a high-energy Q-switched fiber laser has been demonstrated which delivers the ...
Yan Ren +9 more
doaj +1 more source
Highly sensitive refractometer with photonic crystal fiber long-period grating
, 2007 We present highly sensitive refractometers based on a long-period grating in a large mode area PCF. The maximum sensitivity is 1500 nm/RIU at a refractive index of 1.33, the highest reported for any fiber grating.
Bang, Ole, Rindorf, Lars
core +1 more source
, 2003 We consider large-mode area photonic crystal fibers for visible applications where micro-deformation induced attenuation becomes a potential problem when the effective area A_eff is sufficiently large compared to lambda^2.
Baggett +16 more
core +1 more source
High average power, widely tunable femtosecond laser source from red to mid-infrared based on an Yb-fiber-laser-pumped optical parametric oscillator [PDF]
, 2013 We report on the highly efficient generation of widely tunable femtosecond pulses based on intracavity second harmonic generation (SHG) and sum frequency generation (SFG) in a MgO-doped periodically poled LiNbO3 optical parametric oscillator (OPO), which
Fan, Jintao +6 more
core +1 more source
Narrow Linewidth 49 W All Fiber Linearly Polarized Picosecond Laser Operating at 1016 nm
IEEE Photonics Journal, 2022 An all fiber linearly polarized narrow linewidth pulsed fiber laser operating at 1016 nm is demonstrated in a master oscillator power amplification (MOPA) configuration.
Chao Zhang +3 more
doaj +1 more source
Large mode area fibers with asymmetric bend compensation
Optics Express, 2011 Fibers with asymmetrical bend compensation offer to completely remove the tradeoff between mode area and single-modedness, with potentially huge impact on high-power amplification. These fibers would be difficult to fabricate, but are the only fundamental-mode strategy that can remove the bend-distortion limitations on mode-area scaling.
openaire +2 more sources
133-W pulsed fiber amplifier with large-mode-area fiber [PDF]
Optical Engineering, 2006 A master-oscillator fiber power amplifier (MOPA) system with a 4-m-long Yb3+-doped homemade large mode area (LMA) double-clad fiber is reported. The system emits up to 133.8 W of amplified radiation at a wavelength of 1064 nm and a repetition rate of 100 kHz, limited only by the available pump power. Peak power of 300 kW at 20 kHz with a pulse duration
openaire +1 more source
Low-DMGD, Large-Effective-Area and Low-Bending-Loss 12-LP-Mode Fiber for Mode-Division-Multiplexing
IEEE Photonics Journal, 2019 We report the design of 12-LP-mode (21-spatial-mode) fiber with a low differential mode group delay (DMGD), a large effective area, and a low bending loss that is adapted to a mode-division-multiplexing system over the C+L band.
Huan Zhang +4 more
doaj +1 more source
Mitigating mode instabilities by controllable mode beating excitation with a photonic lantern
Frontiers in Physics, 2023 In this study, a method of stabilizing the output beam of a large-mode-area fiber amplifier operating above the mode instability threshold is demonstrated. A mode control system based on the photonic lantern is used to excite dynamic mode beatings as the
Yao Lu +27 more
doaj +1 more source
Millimeter-long Fiber Fabry-Perot cavities
, 2016 We demonstrate fiber Fabry-Perot (FFP) cavities with concave mirrors that can be operated at cavity lengths as large as 1.5mm without significant deterioration of the finesse.
Garcia, Sebastien +6 more
core +3 more sources