Results 11 to 20 of about 91,395,120 (258)
Determination of large diameter bored pile's effective length based on Mindlin's solution
The calculation equation of large diameter bored pile's effective length is connected with its distribution of pile shaft resistance. Thus, there is a great difference between the calculation results under the different distributions of pile shaft ...
Zhijun Zhou +3 more
doaj +2 more sources
Analysis of Cutting Stability of a Composite Variable-Section Boring Bar with a Large Length-to-Diameter Ratio Considering Internal Damping. [PDF]
Chattering in composite deep-hole boring can directly affect surface processing quality and efficiency and has always been a research hotspot in machining mechanics.
Ma J, Xu J, Li L, Liu X, Gao M.
europepmc +2 more sources
The influence of fibre length, diameter and concentration on the strength and strain to failure of glass fibre-reinforced polyamide 6,6 [PDF]
Results of an investigation of the mechanical performance of injection moulded long glass fibre-reinforced polyamide 6,6 composites are presented. The glass fibre content in these composites was varied over the range 10-50% by weight using fibres with ...
Thomason, J.L.
core +3 more sources
The increasing attraction of crude resources on the ocean floor leads to the development of risers, which are an indispensable component of an offshore oil and gas exploitation structure.
Chunguang Wang +4 more
doaj +1 more source
In order to study the separation characteristics of the aeroengine dynamic pressure oil-air separator, this paper uses the coupling method of PBM and CFD two-fluid model to study the influencing factors such as cylinder diameter, cylinder length, and ...
Delin Gu +4 more
core +1 more source
Methane-air explosion pressures in cylindrical interconnected containers with different dimensions
The characteristics of methane-air explosion in interconnected containers with different dimensions are studied in this paper, and the prediction models are established. The explosion apparatus consists of two cylindrical containers and a connecting pipe,
Chendi Lin +3 more
doaj +1 more source
Boiling two-phase pressure drop in small diameter tubes [PDF]
An experimental study of two-phase pressure drop in small diameter tubes is described in this paper. Stainless steel tubes of internal diameter and length of 4.26 mm, 500 mm and 2.01 mm, 211 mm were used. The working fluid was R134a and the range covered
Huo, X +4 more
core +4 more sources
The cylindrical rubber is axially reinforced by the fiber and closed by the rigid ends. When the inner pressure is applied to this fiber reinforced rubber cylinder, the diameter expands and the length shrinks.
Tomoaki TSUJI +4 more
doaj +1 more source
Optimization and Tuning of Passive Tuned Mass Damper Embedded in Milling Tool for Chatter Mitigation
Milling tools with a large length–diameter ratio are widely applied in machining structural features with deep depth. However, their high dynamic flexibility gives rise to chatter vibrations, which results in poor surface finish, reduced productivity ...
Wenshuo Ma +3 more
doaj +1 more source
Large Eddy Simulation of Axial and Compound Angle Holes With Varying Hole Length-to-Diameter Ratio
The effect of hole length to diameter ratio on flat plate film cooling effectiveness and flow structures of axial and compound angle hole is investigated by large eddy simulation (LES).
Wei Shi +9 more
core +1 more source

