Results 111 to 120 of about 3,145,730 (353)
IEEE Photonics JournalThe laser frequency stabilization technology is very important in the development of laser applications, and the improvement of this technology has tend to further expectations for portability and low cost, in addition to the realization of strict ...
Liuxin Zhang +9 more
doaj +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
, 2010 We present an analysis of a semiconductor laser subject to filtered optical feedback from two filtering elements (2FOF). The motivation for this study comes from applications where two filters are used to control and stabilise the laser output.
Slowinski, P. +4 more
core
Stabilization of an AM mode-locked tea CO2 laser [PDF]
, 1983 An increased shot-to-shot reproducibility has been obtained by injection of radiation from a cw CO2 laser in an amplitude mode-locked TEA CO2 laser without additional pulse broadening.
van Goor, F.A.
core +1 more source
Dense wavelength multiplexing for a high power diode laser
, 2022 Paper 61040OAt present methods of polarization and wavelength multiplexing with dielectric coatings are used to increase the brightness of diode lasers.
Traub, M. +3 more
core +1 more source
A Knowledge‐Based Approach for Understanding and Managing Additive Manufacturing Data
Advanced Engineering Materials, EarlyView.Additive manufacturing processes generate a large amount of data. Effectively managing, understanding, and retrieving information from this data remains a major challenge. Therefore, we propose an ontology‐based approach to integrate heterogeneous data, enable semantic queries, and support decision‐making.
Mina Abd Nikooie Pour +5 more
wiley +1 more source
Selective Laser Sintering of a Stainless Steel Powder [PDF]
, 2003 The research presented in this thesis was part of a larger collaborated project (LastForm Programme) to research engineering solutions for the rapid manufacture of large scale (0.5m – 5.0m in length) low, medium and high temperature tooling (from room ...
Hauser, Carl
core
Laser power stabilization via radiation pressure
, 2021 This Letter reports the experimental realization of a novel, to the best of our knowledge, active power stabilization scheme in which laser power fluctuations are sensed via the radiation pressure driven motion they induce on a movable mirror. The mirror
Lanza , R. +16 more
core +1 more source
Soliton stability and interactions in fibre lasers
Electronics Letters, 1992 The stability conditions for soliton generation in fibre lasers are determined, and it is found that soliton interaction forces are reduced by bandwidth limited gain and fast saturable absorption.
Y. KODAMA, M. ROMAGNOLI, WABNITZ, Stefan
openaire +3 more sources
Creating Ti–Fe α/β Alloys by Diffusion‐Driven Solid‐State Processing
Advanced Engineering Materials, EarlyView.This study proposes making alloys containing fast diffusing elements that are difficult to produce by ingot metallurgy, by diffusion‐driven solid‐state HIP processing of elemental powders and low‐temperature homogenisation. Here, novel Fe‐Ti α–β alloys are formed having fine α–β lamellae, a small β prior grain size without significant intermetallics ...
Jiaqi Xu +10 more
wiley +1 more source