Liquid Air Energy Storage Model for Scheduling Purposes in Island Power Systems
Energies, 2022 Moving towards clean energy generation seems essential. To do so, renewable energy penetration is growing in the power systems. Although energy sources such as wind and solar are clean, they are not available consistently.
Mohammad Rajabdorri +2 more
doaj +1 more source
Sensing and Bio-Sensing Research, 2015 Three-dimensional (3D) layer-by-layer graphene-gold nanorod (GNR) architecture has been constructed. The resulting hybrid nanomaterials’ architecture has been tested for detecting hydrogen peroxide (H2O2) through the electrocatalytic reaction on a three ...
Chenming Xue +6 more
doaj +1 more source
A centrifugo-magnetically actuated gas micropump [PDF]
, 2006 This paper describes a novel gas micropump on a centrifugal microfluidic platform. The pump is integrated on a passive and microstructured polymer disk which is sealed with an elastomer lid featuring paramagnetic inlays.
Ducrée, Jens +3 more
core +1 more source
Experimental and theoretical research on the electrical conductivity of a liquid desiccant for the liquid desiccant air-conditioning system: LiCl aqueous solution [PDF]
, 2018 At present, the energy consumption in buildings occupies a large proportion of total energy use, and air-conditionings cost a large proportion of energy in the buildings. The liquid desiccant air-conditioning system has a good energy saving potential and
Cheng, Q, Feng, W, Wang, H, Xu, W
core +1 more source
Energies, 2022 A printed circuit heat exchanger (PCHE) is utilized to cool the compressor inlet air to increase the compression efficiency in a liquid air energy storage and liquid natural gas (LNG) coupled system, which can offer large-scale energy storage with ...
Hu Liu +5 more
doaj +1 more source
Improved TPB-coated Light Guides for Liquid Argon TPC Light Detection Systems [PDF]
, 2015 Scintillation light produced in liquid argon (LAr) must be shifted from 128 nm to visible wavelengths in light detection systems used for liquid argon time-projection chambers (LArTPCs).
Bugel, L. +7 more
core +2 more sources
Revue des Énergies Renouvelables, 2022 This work, based on the data obtained from the literature reported by (Varela et al., 2018), aims to use the artificial neural network approach to predict the heat and mass transfer in a dehumidifier system, using lithium chloride as a liquid desiccant ...
Fatih Bouzeffour
doaj +1 more source
Impact of open de-ionized water thin film laminar immersion on the liquid immersed ablation threshold and ablation rate of features machined by KrF excimer laser ablation of bisphenol A polycarbonate [PDF]
, 2009 Debris control and surface quality are potential major benefits of sample liquid immersion when laser micromachining; however, the use of an immersion technique potentially modifies the ablation mechanism when compared to an ambient air interaction.
C.F. Dowding +23 more
core +2 more sources
Highly processable bulk metallic glass-forming alloys in the Pt–Co–Ni–Cu–P system [PDF]
, 2004 Highly processable bulk metallic glass alloys in the Pt–Co–Ni–Cu–P system were discovered. The alloys show low liquidus temperature below 900 K, excellent processability with low critical cooling rate reflecting in maximum casting thicknesses in quartz ...
Johnson, William L., Schroers, Jan
core +1 more source
Liquid CO2 and Liquid Air Energy Storage Systems: A Thermodynamic Analysis
Energies, 2023 Energy storage is a key factor to confer a technological foundation to the concept of energy transition from fossil fuels to renewables. Their solar dependency (direct radiation, wind, biomass, hydro, etc.
Matteo Marchionni, Roberto Cipollone
doaj +1 more source