Results 61 to 70 of about 403,471 (309)
Fatigue Properties of Long-Term Thermally Aged Low-Alloy Steel
MetalsFatigue properties of low-alloy steels, LAS, are well defined in air and at the beginning of life. However, the potential influence from thermal ageing under conditions relevant for the nuclear industry is uncertain. In this study, the fatigue properties
Robert Magnusson +2 more
doaj +1 more source
Arthritis Care &Research, EarlyView.Objective The aim of this study was to determine the differences in demographic, serologic, and clinical characteristics between male and female patients with systemic sclerosis (SSc) in an Australian cohort. Methods This was a retrospective observational study using data from the Australian Scleroderma Cohort Study.
Emily Lin +14 more
wiley +1 more source
The effect of the number of response cycles on the behaviour of reinforced concrete elements subject to cyclic loading [PDF]
, 2012 The development of damage in reinforced concrete (RC) structures is a cumulative process. Some damage indices used to quantify damage make use of the number of response cycles as an Engineering Demand Parameter (EDP) relating with damage development ...
Borg, R. C., Rossetto, T., Varum, H.
core +1 more source
Arthritis Care &Research, Accepted Article.Objective This study aims to investigate lifestyle‐related factors in patients with psoriatic arthritis (PsA) and their association with disease activity measurements. Methods This multicenter cohort included 938 patients newly diagnosed with PsA, between 2013 and 2023. A composite lifestyle risk score (range 0 to 5) was calculated using five lifestyle‐
Batoul Hojeij +11 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Predicting extreme defects in additive manufacturing remains a key challenge limiting its structural reliability. This study proposes a statistical framework that integrates Extreme Value Theory with advanced process indicators to explore defect–process relationships and improve the estimation of critical defect sizes. The approach provides a basis for
Muhammad Muteeb Butt +8 more
wiley +1 more source
RESEARCH OF HCF/LCF COMBINED CYCLE FATIGUE EXPERIMENTAL TECHNIQUE FOR BLADE
Jixie qiangdu, 2020 To verify the fatigue life under high-low cycle combined loads of the blade the combined fatigue experimental technique was established. The orthogonal loads decoupling method was proposed based on the cylindrical rolled bearing and linear slide rail,and
YOU Yu, ZHANG Wei, WANG ChunSheng
doaj
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Low cycle fatigue and ratcheting failure behavior of AH32 steel under uniaxial cyclic loading
International Journal of Naval Architecture and Ocean Engineering, 2019 In this paper, the low cycle fatigue failure and ratcheting behavior, as well as their interaction of AH32 steel were experimentally investigated under uniaxial cyclic loading.
Qin Dong, Ping Yang, Geng Xu
doaj +1 more source
Low-cycle fatigue testing methods [PDF]
The good design of highly stressed mechanical components requires accurate knowledge of the service behavior of materials. The main methods for solving the problems of designers are: determination of the mechanical properties of the material after cyclic
Lieurade, H. P.
core +1 more source
, 2018 A microstructure-based model that accounts for the effect of grain size has been developed to study the effect of grain size on the fatigue life of Inconel 718 alloys.
Cruzado, A. +3 more
core +1 more source