Results 271 to 280 of about 23,324,241 (344)
Some of the next articles are maybe not open access.
Transactions of the American Institute of Electrical Engineers, 1938
FLUORESCENT lamps have been developed, simple in design, and operating through suitable ballast from 115- and 230-volt a-c circuits. They are tubular in form, and the fluorescent material is energized by a hot-cathode positive-column electric discharge.
G. E. Inman, R. N. Thayer
openaire +1 more source
FLUORESCENT lamps have been developed, simple in design, and operating through suitable ballast from 115- and 230-volt a-c circuits. They are tubular in form, and the fluorescent material is energized by a hot-cathode positive-column electric discharge.
G. E. Inman, R. N. Thayer
openaire +1 more source
Low-voltage differential amplifier
2009 16th IEEE International Conference on Electronics, Circuits and Systems - (ICECS 2009), 2009A low-voltage differential amplifier constructed by bulk-driven PMOS transistors is proposed in this paper. A local positive feedback is utilized that boosts the input transconductance and improve the noise performance. The input common-mode range is also compared to the gate-driven counterpart.
George Raikos, Spiridon Vlassis
openaire +1 more source
A New Switched Capacitor 7L Inverter With Triple Voltage Gain and Low Voltage Stress
IEEE Transactions on Circuits and Systems - II - Express Briefs, 2020In this brief, a new switched capacitor based multilevel inverter topology is proposed. The proposed topology generates seven level (7L) output voltage using a single dc voltage source along with two floating capacitors.
M. Siddique +4 more
semanticscholar +1 more source
IEEE Journal of Solid-State Circuits, 1993
An overall view on low-voltage device and circuit design is presented, beginning with a discussion of the low-voltage limit. Low-voltage device design is then described. Low-voltage CMOS and BiCMOS logic circuits are discussed. Circuit techniques for the low-voltage DRAMs and SRAMs are presented.
Katsuhiro Shimohigashi, Koichi Seki
openaire +2 more sources
An overall view on low-voltage device and circuit design is presented, beginning with a discussion of the low-voltage limit. Low-voltage device design is then described. Low-voltage CMOS and BiCMOS logic circuits are discussed. Circuit techniques for the low-voltage DRAMs and SRAMs are presented.
Katsuhiro Shimohigashi, Koichi Seki
openaire +2 more sources
Advanced Functional Materials
Hard carbon (HC) materials with rich closed pore structures and nano‐scaled soft carbon coating layer have emerged as promising anode in sodium‐ion batteries (SIBs).
Dong Sun +14 more
semanticscholar +1 more source
Hard carbon (HC) materials with rich closed pore structures and nano‐scaled soft carbon coating layer have emerged as promising anode in sodium‐ion batteries (SIBs).
Dong Sun +14 more
semanticscholar +1 more source
Low Voltage Analogue Multiplier
APCCAS 2006 - 2006 IEEE Asia Pacific Conference on Circuits and Systems, 2006With the reduction in supply voltages in order to minimize power dissipation, arises the need for a low voltage analogue multiplier. Developed is a multiplier that operates at as low a voltage as that required to bias a single n-MOS transistor by utilizing CMOS, as against the conventional multipliers which use either n-MOS or p-MOS transistor in the ...
Saurabh Singh, K. Radhakrishna Rao
openaire +1 more source
Low‐Voltage Reversible Electroadhesion of Ionoelastomer Junctions
Advances in Materials, 2020Electroadhesion provides a simple route to rapidly and reversibly control adhesion using applied electric potentials, offering promise for a variety of applications including haptics and robotics.
H. Kim +7 more
semanticscholar +1 more source
Low-voltage arc sustainability
2017 IEEE IAS Electrical Safety Workshop (ESW), 2017Arc Flash in low voltage equipment (480 volts and below) is a safety issue that can impact work practices for electrical workers. When estimating incident energy for low voltage equipment, the duration of the arc is typically the driving factor. This paper summarizes previous testing results that establish arc sustainability for various equipment ...
Marcia L. Eblen, Tom A. Short
openaire +1 more source
Journal of Food Engineering, 2019
The effects of low voltage electrostatic field thawing (LVEFT) on the changes in physicochemical properties of myofibrillar proteins and the quality of thawed beef were investigated. Results showed that by applying LVEFT, thawing process was shortened by
Shu-Yi Qian +6 more
semanticscholar +1 more source
The effects of low voltage electrostatic field thawing (LVEFT) on the changes in physicochemical properties of myofibrillar proteins and the quality of thawed beef were investigated. Results showed that by applying LVEFT, thawing process was shortened by
Shu-Yi Qian +6 more
semanticscholar +1 more source
IEEE transactions on power electronics, 2019
In this paper, state-of-the-art power electronics and energy management solutions utilized in low-power (less than 5 mW), low-voltage (less than 3 V) energy harvesting powered wireless sensors for Internet of things related applications are detailed. All
David Newell, M. Duffy
semanticscholar +1 more source
In this paper, state-of-the-art power electronics and energy management solutions utilized in low-power (less than 5 mW), low-voltage (less than 3 V) energy harvesting powered wireless sensors for Internet of things related applications are detailed. All
David Newell, M. Duffy
semanticscholar +1 more source