Results 241 to 250 of about 9,430,970 (287)
Some of the next articles are maybe not open access.
Realistic Cable Modeling for Low-Voltage Installations
2019 16th International Conference on Synthesis, Modeling, Analysis and Simulation Methods and Applications to Circuit Design (SMACD), 2019Numerical models of electrical cables are important to describe accurately signal propagation in electrical networks. We are interested in the modeling of cables used in low-voltage electrical networks. We observed that numerical cable models exhibit unrealistically sharp resonances and antiresonances.
Stefano Maranò 0003 +4 more
openaire +2 more sources
Water treeing in low voltage cables
IEEE Electrical Insulation Magazine, 2013An investigation of water treeing in a 3 kV XLPE cable removed from the field after more than 25 years of service is presented in the article.
null Wen Shu, null Jun Guo, S. A. Boggs
openaire +1 more source
2020
<div class="section abstract"> <div class="htmlview paragraph">This SAE Standard covers low voltage primary cable intended for use at a nominal system voltage of 60 VDC (25 VAC) or less in surface vehicle electrical systems. The tests are intended to qualify cables for normal applications with limited exposure to fluids and physical abuse.
openaire +1 more source
<div class="section abstract"> <div class="htmlview paragraph">This SAE Standard covers low voltage primary cable intended for use at a nominal system voltage of 60 VDC (25 VAC) or less in surface vehicle electrical systems. The tests are intended to qualify cables for normal applications with limited exposure to fluids and physical abuse.
openaire +1 more source
Influence of cable selection on channel frequency response for low voltage indoor cables
2018 IEEE International Symposium on Power Line Communications and its Applications (ISPLC), 2018The Channel Frequency Response (CFR) is an important parameter in the specification of Power Line Communications (PLC) equipment. In this paper, low voltage indoor power cables are investigated and their suitability for PLC operation determined. This is done in terms of their Channel Frequency Response (CFR).
Arnold S. de Beer +2 more
openaire +1 more source
2020
<div class="section abstract"> <div class="htmlview paragraph">This SAE Standard covers low voltage battery cable intended for use at a nominal system voltage of 60 VDC (25 VAC) or less in surface vehicle electrical systems. The tests are intended to qualify cables for normal applications with limited exposure to fluids and physical abuse.
openaire +1 more source
<div class="section abstract"> <div class="htmlview paragraph">This SAE Standard covers low voltage battery cable intended for use at a nominal system voltage of 60 VDC (25 VAC) or less in surface vehicle electrical systems. The tests are intended to qualify cables for normal applications with limited exposure to fluids and physical abuse.
openaire +1 more source
Design of a low voltage cable fault detector
2000 IEEE Power Engineering Society Winter Meeting. Conference Proceedings (Cat. No.00CH37077), 2002This paper presents a design and construction of a low voltage cable fault location detector. The principle of design is based on the reflection of waves. A pulse is sent into the defective cable and it is reflected back. The interval of travelling waves is identified in order to determine fault location and fault types. The prototype consists of pulse
S. Potivejkul +3 more
openaire +1 more source
2019
The role of the low-voltage grid is changing from being just the final step in the power supply chain to facilitator of renewable energy generation on residential level. Therefore, its importance is steadily increasing in terms of grid reliability. Parts of the low-voltage grid, however, are ageing.
van Deursen, Armand +3 more
openaire +1 more source
The role of the low-voltage grid is changing from being just the final step in the power supply chain to facilitator of renewable energy generation on residential level. Therefore, its importance is steadily increasing in terms of grid reliability. Parts of the low-voltage grid, however, are ageing.
van Deursen, Armand +3 more
openaire +1 more source
Low voltage network cable of a new type
Electrical Engineering, 1933A secondary network cable that will burn clear without producing any smoke, inflammable, explosive, or toxic gases during faults has been developed. Tight and loose faults were cleared satisfactorily in 4 series of tests in underground ducts and vertical conduits without involving adjacent unfaulted phases.
H. O. Anderson, M. C. Cheney
openaire +1 more source
Voltage regulation of cables used IOR low voltage A-C distribution
Electrical Engineering, 1932DISTRIBUTION of alternating current at low voltages does not depend primarily upon the selection of a conductor size which is thermally adequate, but depends upon the voltage regulation limits which will be satisfactory for lighting, especially when combined lighting and power loads are carried on the same circuit. Voltage regulation of a-c circuits is
H. R. Searing, E. R. Thomas
openaire +1 more source
Optimising the design of low-voltage cable networks
IEE Proceedings C Generation, Transmission and Distribution, 1986A procedure is described for selecting cables for radially-connected low-voltage distribution networks of given layout, so that the volume of conductor in the network is a minimum. This corresponds to producing a minimum-capital-cost design when the cost of cables varies linearly with their conductor cross-sectional area.
openaire +1 more source