Results 241 to 250 of about 14,986,572 (302)
Some of the next articles are maybe not open access.
Low-power low-voltage library cells and memories
ICECS 2001. 8th IEEE International Conference on Electronics, Circuits and Systems (Cat. No.01EX483), 2002For future Systems on Chip (SoC) in deep submicron technologies, digital libraries as well as ROM and SRAM memories have to be designed to work at very low supply voltages and to be very robust while considering wire delays, signal input slopes, noise and crosstalk effects.
Christian Piguet +4 more
openaire +1 more source
A CMOS low-voltage low-power temperature sensor
Microelectronics Journal, 2010Temperature sensing circuits are used in a wide range of applications such as in the biomedical area, cold chain monitoring and industrial applications. In the biomedical area, temperature patient monitoring systems can be found in a wide range of hospital applications such as the intensive care unit, surgery rooms and clinical analysis.
Paulo César Crepaldi +2 more
openaire +2 more sources
An ultra low-voltage ultra low-power memristor
2015 9th International Conference on Electrical and Electronics Engineering (ELECO), 2015Memristor can provide new approaches especially in nonlinear & chaotic circuit design. Since no commercially available memristor exist until yet, obtaining of a practical implementation which behaves as a memristor, is very important from the point of view real-world circuit design.
Yener, Suayb Cagri +2 more
openaire +3 more sources
A low-power low-voltage bandgap reference in CMOS
CCECE 2010, 2010A low-voltage low-power bandgap voltage reference in 90nm CMOS is designed and simulated. The overall bandgap architecture is optimized to achieve high accuracy temperature and power supply independent voltage reference. It consists of the bandgap core circuit, op-amp, start-up circuit and output stage.
Na Sun, Robert Sobot
openaire +2 more sources
Low-Voltage Low-Power Amplifiers
1995Low-voltage and low-power amplifiers are strongly limited in dynamic range (DR) and bandwidth (B). The maximum dynamic-range/supply-power ratio is restricted to DR/sub max//P/sub sup/ = /spl pi//16 kTBe by thermal noise in resistors. To obtain this maximum value, several rail-to-rail (R-R) input stages and R-R output stages biased in class-AB are ...
Ron Hogervorst +3 more
openaire +1 more source
A low-voltage low power CMOS companding filter
16th International Conference on VLSI Design, 2003. Proceedings., 2003CMOS companding filters exploit compressed I-V characteristics of MOSFETs and reduce voltage swings at internal nodes, thus allowing large dynamic range in low supply voltage environments. Companding filters replace g/sub m/-c filters in low voltage environments for higher dynamic range.
J. Veerendra Kumar, K. Radhakrishna Rao
openaire +2 more sources
Low voltage swing gates for low power consumption
ISCAS'99. Proceedings of the 1999 IEEE International Symposium on Circuits and Systems VLSI (Cat. No.99CH36349), 2003A low swing voltage design technique is proposed. The new design could be used successfully in order to decrease the power dissipation in Complementary Pass-Transistor Logic (CPL) as in Cascade Voltage Switch Logic (CVSL) logic gates. The achieved gate output voltage-level swing reduction, results in a significant reduction of their power consumption ...
Abdoul Rjoub, Odysseas G. Koufopavlou
openaire +2 more sources
MOSFET technology for low-voltage/low-power applications
IEEE Micro, 1994Certain limits influence MOSFET technology in low-voltage applications. When we reduce the power supply voltage in modern short-channel devices, both active power dissipation and hot carrier reliability improve more than Linearly. However, strong off-state power consumption requirements and increasing numbers of FETs in each integrated circuit ...
Daniel Foty, Edward J. Nowak
openaire +1 more source
A low voltage low power CMOS analog multiplier
2011 NORCHIP, 2011This paper presents a single low-voltage CMOS analog multiplier with low-power consumption. It consists of four voltage adders and a multiplier core. The proposed circuit is simulated with HSPICE and simulation results have shown that, under single 0.9V supply voltage, the circuit has smaller than 1.8% linearity error and 0.88% THD under the maximum ...
Amir H. Miremadi +2 more
openaire +2 more sources
Low-voltage low-power opamp based amplifiers
Analog Integrated Circuits and Signal Processing, 1995Amplifiers operating under low-voltage and low-power conditions are strongly limited in dynamic range and bandwidth. The maximum dynamic range is limited by the supply power and the thermal noise power in resistors. To obtain the maximum, input and output stages should be able to process signals from rail to rail.
Johan H. Huijsing +3 more
openaire +1 more source