Results 91 to 100 of about 523,945 (348)
Development and Research on Fishing Scaling Resistance of Low Carbon Cold Rolled Enamel Steel DC01EK
Teshugang, 2023 Low-carbon cold-rolled fishing scaling resistance enamel steel DCO1EK(/%:C≤0.06,Si≤0.03,Mn:0.15-0.25,P≤0.015,S:0.010-0.020,Alt:0.020-0.040,B:0.0010-0.0020)1.8mm sheet is developed by angang 1780 mm hot continuous rolling 1550 mm cold rolling production ...
厚健龙, 于永业, 向华, 李堃
doaj
The Effects of Cr and Al Addition on Transformation and Properties in Low‐Carbon Bainitic Steels
Metals, 2017 Three low‐carbon bainitic steels were designed to investigate the effects of Cr and Al addition on bainitic transformation, microstructures, and properties by metallographic method and dilatometry.
Junyu Tian +4 more
doaj +1 more source
Towards the production of 50'000 tonnes of low-carbon steel sheet for the LHC superconducting dipole and quadrupole magnets [PDF]
, 2002 A total of 50'000 tonnes of low-carbon steel sheet has been ordered for the LHC main magnets. After three years of production, about 10'000 tonnes of steel sheet have been produced by Cockerill-Sambre Groupe Usinor.
Babic, S +5 more
core +1 more source
Advanced Engineering Materials, EarlyView.The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
Yantu gongcheng xuebaoBased on the life cycle theory of carbon emission of deep foundation pit engineering, a green technology demonstration building project in Shanghai is taken as the background, and the carbon emissions of the foundation pit during life cycle of the all ...
ZHONG Zheng 1, 2, CHEN Jinjian 2, WANG Meihua 1
doaj +1 more source
International Journal of Electrochemical Science, 2019 The thermodynamic calculation results of electrochemical reduction in a NaCl-KCl-NaF-Cr2O3 molten salt system indicates that it is feasible to prepare a Cr coating on low carbon steel by electrochemical deposition.
Shixian Zhang +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
CORROSION of BOILER TUBES in SOUTH BAGHDAD ELECTRIC STATION
Iraqi Journal of Chemical and Petroleum Engineering, 2010 The corrosion of low carbon steel boiler tubes in demi water had been investigated. The purpose of this investigation was to determine the change produced in corrosion behavior of the carbon steel as a result of the specific presence of chloride and ...
Cecilia Kh. Haweel, Janet Lazar
doaj
Влияние исходной термической обработки на особенности ультрамелкозернистой структуры, сформированной в стали 06МБФ методом кручения под давлением [PDF]
, 2009 A homogeneity of strength properties (microhardness) through the specimens and the peculiarities of an ultrafine-grained structure produced in low-carbon steel Fe-Mo-Nb-V-C by cold high-pressure torsion were studied depending on initial heat treatment of
Awakowicz +8 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study investigates thermo‐chemical processes during high‐temperature testing of two commercial MgO‐C brick grades, one containing 47.5 wt.% MgO‐C recyclate. Using ETV, DTA/TG‐MS, XRD, and SEM/EDS/EBSD, mechanisms such as carbothermal reduction of magnesia, impurity incorporation into the secondary MgO surface layer, and calcium‐rich phase ...
Alexander Schramm +6 more
wiley +1 more source