Micromachines, 2020 The present article focused on the surface characterization of electric discharge machined duplex stainless steel (DSS-2205) alloy with three variants of electrode material (Graphite, Copper-Tungsten and Tungsten electrodes). Experimentation was executed
Timur Rizovich Ablyaz +6 more
doaj +2 more sources
Microstructure and surface integrity of machined AZ91 magnesium alloy
Journal of Materials Research and Technology, 2023 AZ91 magnesium alloy is one of the most popular materials among all cast magnesium alloys due to its excellent corrosion resistance and good cast-ability.
A. Asgari, H. Delavar, M. Sedighi
doaj +2 more sources
Modelling the influence of machined surface roughness on the fatigue life of aluminium alloy [PDF]
, 2008 The influence of machined surface roughness on the fatigue life of 7010 aluminium alloy has been investigated. Four-point bending specimen have been machined according to various machining conditions and tested in fatigue.
Chieragatti, Rémy +3 more
core +1 more source
Influence of anodizing process on fatigue life of a machined aluminium alloy [PDF]
, 2010 In order to investigate the coupled effects of machining and anodizing processes on fatigue life of alloy 7010-T7451, a series of rotating bending fatigue tests were conducted at 60Hz.
Chaussumier, Michel +4 more
core +1 more source
Properties Evaluation of Thin Microhardened Surface Layer of Tool Steel after Wire EDM
Metals, 2016 This paper describes results of experimental research on the thin microhardened surface layer of a machined surface that occurs in materials using wire electrical discharge machining (WEDM) with brass wire electrode. The direct influence of microhardened
Ľuboslav Straka +2 more
doaj +1 more source
Influence of cutting process mechanics on surface integrity and electrochemical behavior of OFHC copper [PDF]
, 2014 The authors gratefully acknowledge the support received from IC ARTS and CEA ValducSuperfinishing machining has a particular impact on cutting mechanics, surface integrity and local electrochemical behavior.
Guillaume Fromentin +10 more
core +1 more source
Investigation of Correlation between Image Features of Machined Surface and Surface Roughness [PDF]
, 2020 Alternative approach to surface roughness evaluation is mostly based on the analysis of digital images of machined surfaces i.e. on extracting various features from the matrix mathematically representing a digital image.
Šimunović, Katica +3 more
core +1 more source
Potential fatigue strength improvement of AA 5083-H111 notched parts by wire brush hammering: Experimental analysis and numerical simulation [PDF]
, 2014 The effects of milling as machining process and a post-machining treatment by wire-brush hammering, on the near surface layer characteristics of AA 5083-H111 were investigated.
SIDHOM, Habib +4 more
core +1 more source
Influence of edge radius of sintered-carbide tip on roughness of machined surface
Acta Universitatis Agriculturae et Silviculturae Mendelianae Brunensis, 2013 Increasing of cutting speed and thus increasing labour productivity is observed as a current trend in engineering production. This effort results to development of new cutting materials which are more capable to resist increased requirements on machined ...
Jiří Votava
doaj +1 more source
Investigations of Surface Qualities of Wire EDM Machined Tool Steels [PDF]
, 2021 In the EDM process an electrical discharge occurs between an anode (graphite or copper) and a cathode (material to be machined) in a dielectric medium.
Tóth, László, László Tóth
core +1 more source