Results 71 to 80 of about 9,576,015 (339)
Advances in Materials Science and Engineering, 2021 This study explained about machining parameters of Al5086/Flyash/Sic hybrid metal matrix composites by the Taguchi technique. Al5086 reinforced in SiC (5–10 wt %) and 8% weight of flyash are retained as constants. The specimens are prepared with the help
Bhiksha Gugulothu +4 more
doaj +1 more source
Analysis of cutting parameters in point machining of parts with complex shape [PDF]
, 2018 This paper presents developed SW module in the postprocessor, which is designed to backward analysis of CAM milling toolpath. The module is designed to analyze multi-axis finishing machining of complex shape parts with milling cutters with a circular ...
Rybín J. +3 more
core
A simulated investigation on the machining instability and dynamic surface generation [PDF]
, 2005 In this paper, the authors propose the generic concept of machining instability based on the analysis of all kinds of machining instable behaviors and their features.
Altintas +13 more
core +1 more source
Molecular Oncology, EarlyView.Clinical trials on PARP inhibitors in urothelial carcinoma (UC) showed limited efficacy and a lack of predictive biomarkers. We propose SLFN5, SLFN11, and OAS1 as UC‐specific response predictors. We suggest Talazoparib as the better PARP inhibitor for UC than Olaparib.
Jutta Schmitz +15 more
wiley +1 more source
Experimental research to Optimize Process Parameters in Machining of Non Conducting Material with hybrid non conconventional machining [PDF]
, 2017 Among all non conventional micro machining, electrochemical discharge machining ECDM is having high quality of material removal rate with zero residual stress. This machining has been accepted as a highly modern technology in micromachining.
Kumar, Sunil, Sharma, Vikrant
core
Roughness evolution of previously milled samples along a polishing test [PDF]
, 2016 In the present work results about roughness evolution along a polishing operation with corundum disks of size Norton 400 are presented. Hardened steel and hardened stainless steel samples were previously subjected to ball-end milling or side milling with
Buj Corral, Irene, Vivancos Calvet, Joan
core +2 more sources
Next‐generation proteomics improves lung cancer risk prediction
Molecular Oncology, EarlyView.This is one of very few studies that used prediagnostic blood samples from participants of two large population‐based cohorts. We identified, evaluated, and validated an innovative protein marker model that outperformed an established risk prediction model and criteria employed by low‐dose computed tomography in lung cancer screening trials.
Megha Bhardwaj +4 more
wiley +1 more source
Rotor: Jurnal Ilmiah Teknik Mesin, 2016 The optimization technique of machining parameters considering multiple performance characteristics of non conventional machining EDM process using Taguchi method combined with fuzzy logic is presented in this study.
Galang Sandy Prayogo +2 more
doaj
Results in Materials, 2023 Producing high-quality surfaces from hard and brittle metals presents a formidable challenge that calls for a meticulous machining strategy and an effective cutting tool. The mechanism of tool failure, chip formation behavior, and micro-morphology of the
Farooq Ahmed +4 more
doaj +1 more source
Molecular Oncology, EarlyView.The cancer problem is increasing globally with projections up to the year 2050 showing unfavourable outcomes in terms of incidence and cancer‐related deaths. The main challenges are prevention, improved therapeutics resulting in increased cure rates and enhanced health‐related quality of life.
Ulrik Ringborg +43 more
wiley +1 more source