Results 151 to 160 of about 2,693 (205)
Some of the next articles are maybe not open access.

Related searches:

Nondestructive evaluation of low carbon steel by magnetic adaptive testing

Nondestructive Testing and Evaluation, 2010
Three series of low carbon steel samples, plastically deformed by cold rolling to five consecutive stages of deformation, were investigated by the method of magnetic adaptive testing (MAT), typical by its low required magnetisation of samples. Samples in one series were magnetically closed; those in the other two series were magnetically open.
Gabor Vértesy, Ivan Tomáš
exaly   +2 more sources

A New Magnetic Sensor Concept for Nondestructive Evaluation of Deteriorated Prestressing Strand

Research in Nondestructive Evaluation, 2012
This article describes proof-of-concept testing of a sensor based on magnetic field detection to estimate the remaining effective cross-sectional area in corroded prestressing strands inside prestressed concrete beams. The primary corrosion mode is rusting of the strand.
Vijay Devabhaktuni, Bertrand Fernandes
exaly   +2 more sources

Simulation for nondestructive evaluations by magnetic sensors

IEEE Transactions on Magnetics, 2000
Simulations of the nondestructive evaluation using magnetic sensor were performed for iron based material with local strains caused by tensile stresses up to 540 MPa. The sample had been observed experimentally by magnetic noises and a magnetic leakage flux distributions.
H. Tsuboi   +6 more
openaire   +1 more source

Magnetic nondestructive evaluation of corrosion in wire ropes

Oceans '04 MTS/IEEE Techno-Ocean '04 (IEEE Cat. No.04CH37600), 2005
Wire ropes are used as members to bare very heavy load. The integrity of wire ropes deteriorates with time owing to corrosion, fatigue and abrasion and they finally may break the ropes. As breakage of ropes, especially large diameter ropes, will cause a miserable disaster, preventing from such a disaster we must inspect wire ropes periodically by a ...
T. Moriya, M. Sugawara, K. Tsukada
openaire   +1 more source

Magnetic Nondestructive Testing: Metrological Parameters Evaluation

NDT World, 2015
Metrology is very important for nondestructive testing. The accurate evaluation of NDT instruments and technologies metrological parameters is а problem. It should be taken into consideration that the parameters (such as accuracy, threshold of sensitivity etc.) stated in the delivery documentation can differ significantly from those when the ...
Vasiliy Sukhorukov   +1 more
openaire   +1 more source

Home - About - Disclaimer - Privacy