Predicting the Ms temperature of lean alloyed ferritic–austenitic stainless steels
Journal of Materials Research and TechnologyA set of laboratory hot-rolled and thermally cycled 19–22 wt% Cr lean alloyed ferritic–austenitic stainless steels were studied with respect to calculated equilibrium austenite composition and experimental martensite start (Ms) temperature.
Sampo Uusikallio +4 more
doaj +1 more source
Вестник. Серия физическая, 2008 The new results on reactor (WWR-K) irradiation on kinetic parameters of g®a’ martensitic transformation and true characteristic of strenghr and plasticity of 12Cr18Ni10Ti stainless steel were reported.
O.P. Maksimkin +4 more
doaj +2 more sources
Martensitic Transformation in Austenitic Stainless Steels
, 2009 Martensitic transformation is very important in austenitic stainless steels where the transformation induced plasticity phenomenon provides a combination of good mechanical properties, such as formability and strength. However, the difficulty of predicting the material behaviour is one of the major drawbacks of these steels.
openaire +2 more sources
Electrochemical corrosion resistance and inhibition behaviour of martensitic stainless steel in hydrochloric acid [PDF]
, 2015 Corrosion resistance behaviour of 12Cr martensitic stainless steel was evaluated in different hydrochloric acid and the acid chloride concentrations.
Fayomi, O. S. I +2 more
core
Gaseous surface hardening of martensitic stainless steels
, 2018 The present work addresses heat and surface treatments of martensitic stainless steel EN 1.4028. Different combinations of heat treatments and surface treatments were performed: conventional austenitisation, cryogenic treatment and in particular high temperature solution nitriding (HTSN) and low temperature surface hardening (LTSH).
Tibollo, Chiara +3 more
openaire +2 more sources
Effect of Cu on the Formation of Reversed Austenite in Super Martensitic Stainless Steel. [PDF]
Materials (Basel), 2023 Jiang W, Zhao K.
europepmc +1 more source
Decarburization in Laser Surface Hardening of AISI 420 Martensitic Stainless Steel. [PDF]
Materials (Basel), 2023 Aprilia A, Maharjan N, Zhou W.
europepmc +1 more source
Corrosion Polarization and K2Cr2O7 Inhibition Behaviour of Martensitic Stainless Steel in H3PO4 and H3PO4 + 3.65% NaCl Environments [PDF]
, 2015 The corrosion resistance behaviour of 12Cr martensitic stainless steel was evaluated in different concentrations of H3PO4 and H3PO4 + NaCl. Corrosion inhibition of the tested samples in 1M H3PO4 was also evaluated using potassium dichromate.
Fayomi, O. S. I +2 more
core
Effect of Cu on the Microstructure and Mechanical Properties of a Low-Carbon Martensitic Stainless Steel. [PDF]
Materials (Basel), 2022 Ma J, Song Y, Jiang H, Rong L.
europepmc +1 more source
Use of cyclic current reversal polarization voltammetry for investigating the relationship between corrosion resistance and heat-treatment induced variations in microstructures of 400 C martensitic stainless steels [PDF]
Software for running a cyclic current reversal polarization voltammagram has been developed for use with a EG&G Princeton Applied Research Model 273 potentiostat/galvanostat system.
Ambrose, John R.
core +1 more source