Results 71 to 80 of about 2,449 (185)

Effect of temperature on the corrosion behavior of 13Cr stainless steel under a high CO2 partial pressure environment

工程科学学报, 2015
This article is focused on the effect of temperature on the corrosion electrochemical behavior of 13Cr martensitic stainless steel under a high temperature and high CO2 partial pressure environment.
LI Da-peng, ZHANG Lei, SHI Feng-xian, WANG Zhu, LI Hui, LU Min-xu   +5 more
doaj   +1 more source

Modelling of the austenite-martensite transformation in stainless and TRIP steels

AIP Conference Proceedings, 2013
The transformation of austenite to martensite is a dominant factor in the description of the constitutive behavior during forming of TRIP assisted steels. To predict this transformation different models are currently available. In this paper the transformation is regarded as a stress induced process based on the thermodynamic action of the local ...
Geijselaers, Hubertus J.M., Hilkhuijsen, P., Bor, Teunis Cornelis, Perdahcioglu, Emin Semih, van den Boogaard, Antonius H.   +4 more
openaire   +1 more source

Studying the changes in the pressure transmission coefficient of the ultrasonic waves for ferrous and non-ferromagnetic alloys to find some of the most significant mechanical properties

Scientific Reports
This study is the most important part of the technique of using the pressure transmission coefficient (PTC) of the ultrasonic waves in extracting the most important mechanical properties (yield stress and ultimate strength) of alloys in general.
Arshed Abdulhamed Mohammed, Sallehuddin Mohamed Haris   +1 more
doaj   +1 more source

Predicting the Ms temperature of lean alloyed ferritic–austenitic stainless steels

Journal of Materials Research and Technology
A set of laboratory hot-rolled and thermally cycled 19–22 wt% Cr lean alloyed ferritic–austenitic stainless steels were studied with respect to calculated equilibrium austenite composition and experimental martensite start (Ms) temperature.
Sampo Uusikallio, Aarne Pohjonen, Pentti Kaikkonen, Oskari Haiko, Jukka Kömi   +4 more
doaj   +1 more source

Effect of heat treatment on micro structure, hardness, high temperature oxidation resistance of martensitic stainless steel 13Cr3Mo3Ni-cast

Teknik, 2019
This paper reports the effect of heat treatment on microstructure, hardness and high-temperature oxidation resistance of martensitic stainless steels13Cr3Mo3Ni-cast.
Moch Syaiful Anwar, Eric Jonathan Yulianto, Septian Adi Chandra, Rahma Nisa Hakim, Sri Hastuty, Efendi Mabruri   +5 more
doaj   +1 more source

THE KINETICS DEVOLOPMENT OF MARTENSITE DEFORMATION IN STAINLESS STEEL 12Cr18Ni10Ti IRRADIATED BY NEUTRON

Вестник. Серия физическая, 2008
The new results on reactor (WWR-K) irradiation on kinetic parameters of g®a’ martensitic transformation and true characteristic of strenghr and plasticity of 12Cr18Ni10Ti stainless steel were reported.
O.P. Maksimkin, A.I. Emelyanov, A. Naltaev, D.T. Berdalyev, B.K. Rakhashev   +4 more
doaj   +2 more sources

Effect of Cu on the Formation of Reversed Austenite in Super Martensitic Stainless Steel. [PDF]

Materials (Basel), 2023
Jiang W, Zhao K.
europepmc   +1 more source

Decarburization in Laser Surface Hardening of AISI 420 Martensitic Stainless Steel. [PDF]

Materials (Basel), 2023
Aprilia A, Maharjan N, Zhou W.
europepmc   +1 more source

Martensitic Transformation in Austenitic Stainless Steels

, 2009
Martensitic transformation is very important in austenitic stainless steels where the transformation induced plasticity phenomenon provides a combination of good mechanical properties, such as formability and strength. However, the difficulty of predicting the material behaviour is one of the major drawbacks of these steels.
openaire   +2 more sources

Effect of Cu on the Microstructure and Mechanical Properties of a Low-Carbon Martensitic Stainless Steel. [PDF]

Materials (Basel), 2022
Ma J, Song Y, Jiang H, Rong L.
europepmc   +1 more source