Results 11 to 20 of about 11,477,062 (289)
Flow rate measurement of rarefied binary gases in long rectangular microchannels [PDF]
This paper was presented at the 3rd Micro and Nano Flows Conference (MNF2011), which was held at the Makedonia Palace Hotel, Thessaloniki in Greece.
Szalmas, L +3 more
core +6 more sources
Evaluation of electroosmotic pumping effect in microporous media flow [PDF]
This paper was presented at the 3rd Micro and Nano Flows Conference (MNF2011), which was held at the Makedonia Palace Hotel, Thessaloniki in Greece.
Yan, Y +2 more
core +6 more sources
High Accuracy Volume Flow Rate Measurement Using Vortex Counting [PDF]
A prototype device for measuring the volumetric flow-rate by counting vortices has been designed and realized. It consists of a square-section pipe in which are placed a two-dimensional bluff body and a strain gauge force sensor.
RAVELET, Florent +3 more
core +1 more source
Spatiotemporal evolution and fluctuation characteristics of a centrifugal compressor are investigated by numerical simulation under near-stall conditions and with a high mass-flow rate.
Kang Xiao +3 more
doaj +1 more source
Direct numerical simulations of mass transfer in square microchannels for liquid-liquid slug flow [PDF]
Microreactors for the development of liquid-liquid processes are promising technologies since they are supposed to offer an enhancement of mass transfer compared to conventional devices due to the increase of the surface/volume ratio.
Di Miceli Raimondi, Nathalie +3 more
core +1 more source
Prediction of Mass Flow Rate in Supersonic Natural Gas Processing
The mass flow rate of natural gas through the supersonic separator was numerically calculated by various cubic equations of state. The numerical results show that the compressibility factor and specific heat ratio for ideal gas law diverge remarkably ...
Wen Chuang +3 more
doaj +1 more source
In the current research an experimental study was done to show the effect of pulse flow on the effectiveness of shell and tube type heat exchanger. the study was in the case of steady and pulse flows with a changing mass flow rate of hot water flowing ...
Zuher Hassan Abdullah +2 more
doaj +5 more sources
Printed circuit heat exchangers (PCHEs) are widely used as recuperators in the supercritical carbon dioxide (S-CO2) Brayton cycle design. The variation of heat sources will have a great impact on the heat transfer effect of the recuperator.
Kun Xi +4 more
doaj +1 more source
Evaluation of Virtual Refrigerant Mass Flow Sensors [PDF]
Refrigerant mass flow rate is an important measurement for monitoring equipment performance and enabling fault detection and diagnostics. However, a traditional mass flow meter is expensive to purchase and install. A virtual refrigerant mass flow sensor (
Kim, Woohyun, Braun, James E.
core +1 more source
In order to accurately reflect the characteristics and motion states of a pneumatic rotary actuator position servo system, an accurate non-linear model of the valve-controlled actuator system is proposed, and its parameter identification and experimental
Yeming Zhang +4 more
doaj +1 more source

