Results 61 to 70 of about 8,552 (232)
Advanced Experiment Design Strategies for Drug Development
Wang et al. analyze 592 drug development studies published between 2020 and 2024 that applied design of experiments methodologies. The review surveys both classical and emerging approaches—including Bayesian optimization and active learning—and identifies a critical gap between advanced experimental strategies and their practical adoption in ...
Fanjin Wang +3 more
wiley +1 more source
X-ray diffraction and SEM/EDX studies on technological evolution of the oxide-fluoride ceramic flux for submerged arc-surfacing [PDF]
The ceramic flux for submerged arc-surfacing with main component composition MgO (10.0 wt. %)-Al2O3 (25.0 wt. %)-SiO2 (40.0 wt. %)-CaF2 (25.0 wt. %) was prepared in a disk dryer-granulator using a sodium/potassium silicate solution as a binder.
Sokolsky V.E. +6 more
doaj +1 more source
REPEATING POLYETHYLENE DERIVATIVES OF THE LOW DENSE OF HRYBVOVITSKY DUMP [PDF]
The dump in the village Veliky Gribovitchy near the city of Lviv (Lviv Solid Waste Landfill) is one of the largest environmental pollutants in the Lviv region. At present, the landfill is closed.
Khromyak, Uliana, Tarnavskyj, Andrij
core
ABSTRACT This study examined whether enzymatic modification of soybean oil (SBO) can be tailored to produce trans‐free fats with physicochemical properties comparable to palm olein, stearin, or palm‐mid fractions (PMFs). US‐grown SBO was modified by lipase‐catalyzed acidolysis using palmitic acid at linearly interpolated substrate molar ratios (C16:0 ...
Ityotagher P. Aondoakaa +2 more
wiley +1 more source
Evaluation of preparation methods for orally disintegrating tablets
Oral disintegrating tablets (ODT) are orally administered solid dosage forms commonly used in pediatric and geriatric patients with difficulty in swallowing.
Yagmur Akdag +5 more
doaj +1 more source
PP/SEBS/MA/ZnO filaments produced by bench‐top single‐screw extrusion show refined morphology, increased crystallinity, improved thermal robustness, and preliminary FFF printability, demonstrating a practical route for functional filament development. ABSTRACT Currently, single‐screw extrusion offers a versatile and accessible route to produce polymer ...
Chiara das Dores do Nascimento +12 more
wiley +1 more source
Scaling of Planar Sodium‐Nickel Chloride Battery Cells to 90 cm2 Active Area
Large planar Na β′′ alumina electrolytes are prepared by tape‐casting and die‐pressing. These ceramic electrolytes are used to prepare planar sodium‐nickel chloride cells with 90 cm2 active area, providing a high capacity of 7 Ah. Successful cell cycling is demonstrated at 300 °C at rates up to C/4 (20 mA cm−2) for a cumulative capacity of 3.6 Ah cm−2.
T. Lan +10 more
wiley +1 more source
Melt Granulation as a Modern Technological Procedure [PDF]
The majority of active agents used in medicinal therapy belong to category BCS II, which means that they have poor dissolution and good absorption properties, thus their absorption can be controlled and promoted first of all with various formulation technologies. [...]
openaire +1 more source
Biomaterial design strategies for enhancing mitochondrial transplantation therapy
Biomaterials to facilitate mitochondrial transplantation therapy: biomaterials as barriers to protect mitochondria from pathophysiological microenvironments, like osmotic stress caused by the excessive concentration of calcium ion, reactive oxygen species, and advanced glycation end products; biomaterials integrating with biochemical cues to improve ...
Shaoyang Kang +12 more
wiley +1 more source
Tolperisone HCl is a centrally muscles relaxant drug. It is a highly water-soluble drug. It has a biological half-life of 1.5–2.5 h. It has absorption window in the small intestine and unstable in intestinal pH 4 to 7.
Ankita U. Patel +3 more
doaj +1 more source

