Two basic ways to realise DC circuit breakers
As a key element of the DC grid, the technology of DC circuit breakers (DCCBs) still have difficulty to be widely used due to its large cost and volume. This paper studies the basic principle and its realisation methods for DCCBs.
Zheng Xu +3 more
doaj +1 more source
Reduction Reactive Power and Collapse Voltage Using Series Capacitors Compensation in Sudden Change Loads of Transmission Lines [PDF]
The continuous increase of disturbances on the interconnected electric power system resulting in its inability to reliably meet demands. This paper presents an application of a series capacitor compensation in transmission line and shunt reactors ...
Hussein Thani Rishag
doaj +1 more source
Influence of UHV GIL access on transient recovery voltage of circuit breaker
The access of ultra high voltage (UHV) gas-insulated transmission line (GIL) affects both the transient recovery voltage (TRV) amplitude and the rate of rise of TRV (RRRV) of circuit breakers,which may endanger the breaking capacity of circuit breakers ...
SUN Yi +5 more
doaj +1 more source
Ultra‐Rapid Blacklight Sintering for ZnO‐Based Varistors With Optimized Functional Properties
ABSTRACT The increasing demand for energy‐efficient optoelectronic systems has intensified interest in high‐performance ceramic varistors, which are critical components in surge protection applications. In this study, ZnO‐based varistors were fabricated using a novel blacklight sintering (BLS) technique, which employs high‐powered blue light, and were ...
Ahmad Sayyadi‐Shahraki +4 more
wiley +1 more source
dv/dt Dependence in metal oxide varistors
A dv/dt dependence has been observed in metal oxide varis-tors during impulse testing. A lossy dielectric model which provides a qualitative explanation of this behaviour can also be used to account for current overshoot.
de Cogan, D., Leesen, M.
openaire +2 more sources
Grain Boundary Space Charge Engineering of Solid Oxide Electrolytes: Model Thin Film Study
This study demonstrates unprecedented control of grain boundary electrical properties in solid electrolytes. Selective diffusion of cations through grain boundaries in thin films enables 12 orders of magnitude variation in ionic resistance, proving that systematic chemical modification of grain boundary electrical properties is feasible.
Thomas Defferriere +5 more
wiley +1 more source
Surface Flashover in 50 Years: III. Extreme Environments and Industrial Challenges
ABSTRACT Modern high‐voltage electrical equipment operates in complex environments where surface conditions are subjected to multifaceted influences from electric fields, thermal gradients, contaminants, irradiation and other extreme environmental factors.
Zhen Li +6 more
wiley +1 more source
Development of a Low-Energy Mobile Current Waveform Impulse Generator for Application in Low Voltage Surge Arresters [PDF]
Surge arresters are at the forefront of protection against voltage surges. The loss of the protective effect of surge arresters imposes accidents and unplanned shutdowns on the power system.
Tiago Goncalves Zacarias +9 more
doaj +1 more source
ABSTRACT With the development of deep‐sea wind power and large‐scale onshore clean energy, the global demand for higher voltage level DC cable power transmission technology has become increasingly urgent. This paper systematically reviews the technical advancements in high voltage direct current (HVDC) cable accessories, addressing design challenges of
Zongxi Liu +5 more
wiley +1 more source
Investigation of Limitations in Passive Voltage Clamping-Based Solid-State DC Circuit Breakers
This paper investigates limitations of passive voltage clamping based dc solid-state circuit breakers (SSCBs). There are two major contributions of this paper.
Shuyan Zhao +4 more
doaj +1 more source

