Characterization of Particle Size Effects on Sintering Shrinkage and Porosity in Stainless Steel Metal Injection Molding Using Multi-Physics Simulation. [PDF]
Materials (Basel)Wu Y, Guo K, Ni J.
europepmc +1 more source
Paraffin Graphite Composite Spheres for Thermal Energy Management. [PDF]
Materials (Basel)Thalmaier G +3 more
europepmc +1 more source
Optimization of the Metal Injection Molding Process with 3l6L Stainless Steel Powder and Influence Analysis of Process Parameters Using the Taguchi-MADM-Based Hybrid Method. [PDF]
ACS OmegaRi RH, Yang WC.
europepmc +1 more source
Metal Injection Molding of Ti-Mo-Al Mixed Powder.
Journal of the Japan Society of Powder and Powder Metallurgy, 1994 openaire +2 more sources
High-Efficiency Surface-Cooled Rapid Tooling Development for Injection Molding of Low-Density Polyethylene. [PDF]
Polymers (Basel)Kuo CC +4 more
europepmc +1 more source
Optimization of Metal Injection Molding Processing Conditions for Reducing Black Lines and Meld Lines in Bone Plates. [PDF]
Polymers (Basel)Lin CM, Yen PY, Tan CM.
europepmc +1 more source
Recycling Waste Fiberglass by Powder Grinding and Direct Molding of Powders. [PDF]
Polymers (Basel)Quadrini F +4 more
europepmc +1 more source
Micro Metal Powder Injection Molding in the W-Cu System [PDF]
Journal of Korean Powder Metallurgy Institute, 2002 openaire +1 more source
Investigation of the effects of different denture base fabrication techniques and hard relining resin materials on the fixation of immediate provisional hybrid prosthesis to titanium cylinders. [PDF]
BMC Oral HealthKanat-Ertürk B, Akarsu C, Tak Ö.
europepmc +1 more source
Titanium dioxide nanoparticles on flexural strength of conventional and injection moulded denture base materials. [PDF]
BioinformationRao UM +5 more
europepmc +1 more source