Progress in bone tissue engineering biomaterials: Development, challenges, and prospects
Scheme 1 Application of biomaterials in immunomodulation during bone tissue engineering. Abstract Bone defect repair remains a major clinical challenge in orthopedics. Over 2 million cases caused by trauma, tumors, and other factors occur annually, with large‐scale defects posing a particular bottleneck due to limited self‐healing capacity.
Yuanbin Zhang +7 more
wiley +1 more source
Detection of Germanium Nanocrystals as Tracer Materials in Polypropylene via Raman Spectroscopy. [PDF]
Greiner M +6 more
europepmc +1 more source
Effecft of co‐doping polyaniline with phosphoric acid and phytic acid on the heat release rate of polyethylene. Abstract Polyolefins, such as polyethylene (PE), are highly flammable and electrically insulative, limiting their applicability. The study explored the flame‐retardancy and electrical conductivity of PE/polyaniline (PE/PANI) nanocomposites ...
Akeem Adisa +4 more
wiley +1 more source
Micro Metal Powder Injection Molding Technology
openaire +2 more sources
ABSTRACT To address the issue of low detection accuracy for zero‐value insulators in distribution lines, this study proposes a novel method for detecting these insulators based on the electroluminescence effect. Through theoretical analysis and experimentation, it was found that the luminescence intensity of ZnS:Cu electroluminescent material varies ...
Jianghai Geng +6 more
wiley +1 more source
Three-Dimensional Thermal Conductive Modeling of Hybrid Thermal Conductive Powders Filled POK-Based Composites. [PDF]
Altay L, Sarikanat M, Tokgoz MM, Seki Y.
europepmc +1 more source
Biocompatibility With Osteogenic Potential of Premixed Bioceramic Cements for Use in Apical Surgery
ABSTRACT This study investigated the biocompatibility and osteogenic potential of premixed bioceramic cements (PBCs)—CeraPutty, EndoCEM MTA Premixed, Well‐Root PT, and One‐Fil PT Injectable—as alternatives to mineral trioxide aggregate for retrograde filling in endodontic microsurgery.
Yesol Kim +5 more
wiley +1 more source
Research on Bi-Objective Optimization of Injection Molding Process and Mechanical Anisotropy of Glass Fiber-Reinforced Polypropylene Fan Face Shell Based on RSM and NSGA-II. [PDF]
Yang M, Yan S, Liu J, Li F, Yao J, Li Y.
europepmc +1 more source
The Impact of Pressure-Dependent Viscosity Data on Injection Molding Simulations of Highly Filled Thermoplastics. [PDF]
Kerling F +5 more
europepmc +1 more source
Abstract Purpose To evaluate the mechanical properties of lithium disilicates, and to assess the predictive capability of in silico models for biaxial flexural strength (BFS). Materials and Methods Specimens of four heat‐pressed lithium disilicates (IPS e.max Press, Rosetta SP, LiSi Press, Vintage Prime Press) were obtained.
Larissa M. M. Alves +12 more
wiley +1 more source

