Results 41 to 50 of about 101,882 (158)
A passive wireless surface acoustic wave sensor for pillar load measurement
This paper presents a passive wireless pillar load measurement method based on surface acoustic wave (SAW) technology. A strain transfer mechanical structure was designed, and the strain distribution of an elastic substrate was analyzed using elastic ...
Yanping Fan +5 more
doaj +1 more source
When large amounts of wind power and solar photovoltaic (PV) power are integrated into an independent power grid, the intermittent renewable energy destabilizes power output.
Shiue-Der Lu +4 more
doaj +1 more source
Objective To evaluate the impact of the residual setup errors from differently shaped region of interest (ROI) and investigate if surface-guided setup can be used in radiotherapy with concurrent tumor treating fields (TTFields) for glioblastoma.
Jiajun Zheng +8 more
doaj +1 more source
In hostile environments, engine damage is of particular concern since the engine is the only component to generate thrust that affects survivability.
Zhiwei Chen +3 more
doaj +1 more source
Face Recognition using Similarity Pattern of Image Directional Edge Response
An effective face descriptor is critical for a successful face recognition system and must overcome the challenges of changing environment. The face representation must have discriminatory information and be computationally feasible for any face ...
BASHAR, F. +3 more
doaj +1 more source
A Component-level Resistance Characteristic Prediction Method for Marine Gas Turbine Intake Systems Based on a Neural Network Model [PDF]
In order to improve the accuracy and efficiency of resistance characteristic prediction of marine gas turbine intake system, a resistance characteristic prediction method based on component-level numerical simulation and neural network model is proposed ...
J. Dai +6 more
doaj +1 more source
A Stress-Sensitivity-Based Process Optimization Method for Machining Thin-Walled Parts
Thin-walled partition frame parts are key load-bearing components in aerospace structures. Machining deformation directly affects assembly accuracy and service reliability.
Haili Jia +4 more
doaj +1 more source
Strain gage mounted on the surface of the shafts with specified directions are one of the common methods for measurement of the torsion in shafts. The most critical problem in utilization of this method, particularly in the online monitoring of torsional
Mohammad samavatian +4 more
doaj
The study reveals that neglecting the yaw-direction rotational friction moment of the support foot in a self-balancing lower-limb exoskeleton (SBLLER) causes gait trajectory deviation. However, conventional momentum compensation strategies are unsuitable
Shisheng Zhang +6 more
doaj +1 more source
The purpose of this study was to evaluate the reproducibility and magnitude of shift of tumor position by using active breathing control and iView-GT for patients with lung cancer with moderate deep-inspiration breath-hold (mDIBH) technique.
Muralidhar K +5 more
doaj

