Results 121 to 130 of about 1,225,394 (336)
Photoinduced Coupling of Acetylenes and Quinone in the Solid State as Preorganized Donor−Acceptor Pairs [PDF]
Crystalline electron donor−acceptor (EDA) complexes of various diarylacetylenes (DA) and dichlorobenzoquinone (DB) are isolated and structurally characterized by X-ray crystallography.
Bosch, E. +3 more
core +1 more source
Advanced purification of methyl orange high concentration
Abstract A simple process, vacuum distillation, was utilized for purification of methyl orange (MO) as dye effluent. The dye effluent characteristic of high chemical oxygen demand (COD) value and high chromaticity is difficult to treat for the industrial wastewater treatment.
Qingliang Ma +3 more
openaire +1 more source
The combination of formamidinium thiocyanate and 1,3‐propane diammonium iodide for bulk and top‐surface passivation, and a ternary fullerene blend to improve energy band alignment, suppresses energy losses in wide‐bandgap FAPbBr3 perovskite solar cells.
Laura Bellini +9 more
wiley +1 more source
Zinc oxide nanoparticles (ZnO NPs) were prepared using the sol–gel method. Cotton fibers were loaded with ZnO nanoparticles using sol–gel spin coating technique.
Mohamed Shaban +2 more
doaj +1 more source
Optimasi Fotodegradasi Metil Oranye Menggunakan Fotokatalis Tio2/al2o3 Montmorilonit [PDF]
: Dispersion of TiO2 on montmorillonite pillared aluminium has been done successfully. The photocatalyst were prepared by intercalation of Al13 onto natural montmorillonite and then calcined at 500oC.
Sumarlan, I. (Iwan)
core +2 more sources
Na‐ion batteries ‐ Impact of doping on the oxygen redox: The sloping potential of NaMg0.1Ni0.4Mn0.5O2 above 4.0 V is caused by a new redox center (arising from the ‘O bound to Mg’), having a higher potential but being more irreversible compared to the ‘O bound to Ni’.
Yongchun Li +12 more
wiley +1 more source
Colloidal Crack Sintering Lithography for Light‐Induced Patterning of Particle Assemblies
Colloidal crack sintering lithography (CCSL) is a microfabrication technique that uses light‐induced photothermal heating to trigger sintering and controlled cracking in polymer colloidal assemblies. Local structural changes generate microchannels and patterns, enabling direct writing of diverse topographic motifs.
Marius Schoettle +2 more
wiley +1 more source
Background: As for the enhancement of the various industries such as loom industry, the reduction of the pollutants in the sewerage of these industries is focused by protection office of environment.
Sedigheh Abbasi
doaj
The binding of dyestuffs by proteins [PDF]
Thesis (M.A.)--Boston ...
Scully, Margaret A
core +1 more source

