Results 71 to 80 of about 88,689 (248)
Noise as Diagnostic Tool for Quality and Reliability of MEMS
Sensors, 2021 This perspective explores future research approaches on the use of noise characteristics of microelectromechanical systems (MEMS) devices as a diagnostic tool to assess their quality and reliability.
Faisal Mohd-Yasin, David J. Nagel
doaj +1 more source
Advanced Science, EarlyView.ABSTRACT The multifunctional integration of chips with high flexibility and scalable manufacturing is crucial for enhancing chip performance, reducing chip size, and simplifying chip design. However, balancing volume, cost, flexibility, and functionality using traditional heterogeneous integration methods is challenging.
Lang Chen +7 more
wiley +1 more source
Phase Noise Reduction in a VHF MEMS-CMOS Oscillator Using Phononic Crystals
IEEE Journal of the Electron Devices Society, 2016 This paper presents experimental results showing reduced phase noise in a very high frequency band microelectromechanical systems (MEMS) oscillator. This has been achieved by engineering the embedded MEMS resonator with phononic crystal structures.
Pei Qin +3 more
doaj +1 more source
Recent Advances in Programmable Metasurfaces and Meta‐Devices
Advanced Electronic Materials, EarlyView.Programmable metasurfaces enable various novel functionalities by dynamically tuning electromagnetic wavefronts. This article provides a comprehensive review of recent advances in microwave and terahertz programmable metasurfaces, covering electrical, thermal, optical, and mechanical control mechanisms.
Linda Shao +4 more
wiley +1 more source
Three-axis piezoresistive accelerometer with adjustable axial resolutions
Vietnam Journal of Mechanics, 2012 A three-axis piezoresistive accelerometer which has adjustable resolutions to three axes was developed using MicroElectroMechanical Systems (MEMS) technology.
Bui Thu Hang +2 more
doaj +1 more source
A micromachined flow shear-stress sensor based on thermal transfer principles [PDF]
, 1999 Microhot-film shear-stress sensors have been developed by using surface micromachining techniques. The sensor consists of a suspended silicon-nitride diaphragm located on top of a vacuum-sealed cavity.
Ho, Chih-Ming +6 more
core
Accurate Telescope Mount Positioning with MEMS Accelerometers [PDF]
, 2014 This paper describes the advantages and challenges of applying microelectromechanical accelerometer systems (MEMS accelerometers) in order to attain precise, accurate and stateless positioning of telescope mounts.
Csépány, Gergely +3 more
core +2 more sources
Microstructured Tactile Sensors With Bismuth Telluride Coatings for Vibration Detection
Advanced Electronic Materials, EarlyView.The study reports a high‐performance piezoresistive vibration sensor (PVS) based on a Bi₀.5Sb₁.5Te3 functional layer on a PDMS microstructured substrate. The device exhibits high sensitivity (0.24 kPa−1), fast response, and excellent durability over 10 000 cycles.
Yikun Liu +8 more
wiley +1 more source
, 2010 This paper presents a preliminary study into stiction between parylene C and substrate surfaces for biocompatible check-valve applications. During fabrication, parylene C is used as the structural material for the check-valve.
Chen, Po-Jui +3 more
core +1 more source
Energy Science &Engineering, EarlyView.Ultra‐lean H2 micro‐combustor performance is boosted through regulated O2 enrichment and inlet preheating. A 16‐case Taguchi study (ϕ = 0.3) shows: controlled enrichment and heating increase radiative output and efficiency, but excessive O2/temperature causes flashback.
Anouar Benzitouni +4 more
wiley +1 more source