Results 151 to 160 of about 307,700 (210)
Miniaturized broadband lowpass filter based on the integrated square dumbbell and meander structure spoof surface plasmon polaritons. [PDF]
Yang L, Ye W, Cai B, Cao C, Cheng Y.
europepmc +1 more source
A Compact Wideband Millimeter-Wave Crossover for Phased Array Antenna Systems in Remote Sensing Applications. [PDF]
Ahmed FH, Saad R, Khamas SK.
europepmc +1 more source
A high-selectivity 24-GHz SIW-DGS-CPW bandpass filter with wide stopband rejection for automotive radar and ADAS. [PDF]
Abada AM +3 more
europepmc +1 more source
A Design Technique for Microstrip Filters
Most communication systems contain an RF front end, which performs analogue signal processing with RF filters. Microstrip filters are a low cost means of doing this. This paper describes a general design technique for microstrip or stripline filters. Four different microstrip filters are designed. The simulated and measured responses agree closely over
Kikkert, Cornelis Jan
core +3 more sources
Compact Dual-Mode Open Loop Microstrip Resonators and Filters [PDF]
A novel compact microstrip dual-mode resonator and filter are proposed. The characteristics of the dual mode resonator are investigated. It is found that the filter response exhibits a desirable stopband response where the first spurious passband ...
Djuradj Budimir
exaly +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
33rd European Microwave Conference, 2003, 2003
A conventional microstrip ring resonator when folded up into a more compact structure is shown to exhibit similar characteristics to the annular-ring resonator. The folded ring resonator can resonate at identical resonant modes as the annular-ring resonator, which is designed to operate at the same fundamental mode frequency when fabricated on an ...
B.S. Virdee, C. Grassopoulos
openaire +1 more source
A conventional microstrip ring resonator when folded up into a more compact structure is shown to exhibit similar characteristics to the annular-ring resonator. The folded ring resonator can resonate at identical resonant modes as the annular-ring resonator, which is designed to operate at the same fundamental mode frequency when fabricated on an ...
B.S. Virdee, C. Grassopoulos
openaire +1 more source
Nonreflective microstrip filter
2016 17th International Conference of Young Specialists on Micro/Nanotechnologies and Electron Devices (EDM), 2016The article presents design for nonreflective microstrip filters based on the ring resonators and shows its calculation methods. The presented notch filter provides a high filtering due to the additional zeros of transmission index in stop band and is characterized by simplicity of design implementation.
Valentina M. Goychuk +2 more
openaire +1 more source
2000 10th International Crimean Microwave Conference. "Microwave and Telecommunication Technology". Conference Proceedings (IEEE Cat. No.00EX415), 2000
In this paper presented is the design of microstrip filter having fractional bandwidth up to 100% and being stable against heightened levels of power.
B.A. Belyaev +3 more
openaire +1 more source
In this paper presented is the design of microstrip filter having fractional bandwidth up to 100% and being stable against heightened levels of power.
B.A. Belyaev +3 more
openaire +1 more source
11th International Conference 'Microwave and Telecommunication Technology'. Conference Proceedings (IEEE Cat. No.01EX487), 2002
Broadband microstrip filters based on quarter wave irregular resonators were investigated. The possibility of realization of miniature devices with fractional bandwidth up to 100% and with highly selective properties was shown.
B.A. Belyaev +2 more
openaire +1 more source
Broadband microstrip filters based on quarter wave irregular resonators were investigated. The possibility of realization of miniature devices with fractional bandwidth up to 100% and with highly selective properties was shown.
B.A. Belyaev +2 more
openaire +1 more source
Single-Sided Filters in Microstrip Technology
31st European Microwave Conference, 2001, 2001This paper describes how to approach the design of microstrip filters with requirements in one passband and one stopband, both of finite extension (single-sided filters). Suitable filter topologies have been investigated, which allow having the filter passband either above or below the filter stopband.
A. Bovatti, MACCHIARELLA, GIUSEPPE
openaire +2 more sources

