Results 161 to 170 of about 14,280 (219)
A microstrip bandpass filter using coupled lines loaded by open stubs. [PDF]
Kahkesh SH, Sheikhi A.
europepmc +1 more source
Design of tri-band bandpass filter based on the interdigital structure and rectangular resonator for LTE and radar applications. [PDF]
Zarghami S, Jahanbakhshi M.
europepmc +1 more source
Surrogate-Assisted Differential Evolution for the Design of Multimode Resonator Topology. [PDF]
Stanovov V +4 more
europepmc +1 more source
Eight-Port millimeter wave MIMO antenna loaded with novel frequency selective surface for higher data rate transmission. [PDF]
Soman M, Sharma M, Narwal S, Ali T.
europepmc +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
33rd European Microwave Conference, 2003, 2003
A conventional microstrip ring resonator when folded up into a more compact structure is shown to exhibit similar characteristics to the annular-ring resonator. The folded ring resonator can resonate at identical resonant modes as the annular-ring resonator, which is designed to operate at the same fundamental mode frequency when fabricated on an ...
B.S. Virdee, C. Grassopoulos
openaire +1 more source
A conventional microstrip ring resonator when folded up into a more compact structure is shown to exhibit similar characteristics to the annular-ring resonator. The folded ring resonator can resonate at identical resonant modes as the annular-ring resonator, which is designed to operate at the same fundamental mode frequency when fabricated on an ...
B.S. Virdee, C. Grassopoulos
openaire +1 more source
2000 10th International Crimean Microwave Conference. "Microwave and Telecommunication Technology". Conference Proceedings (IEEE Cat. No.00EX415), 2000
In this paper presented is the design of microstrip filter having fractional bandwidth up to 100% and being stable against heightened levels of power.
B.A. Belyaev +3 more
openaire +1 more source
In this paper presented is the design of microstrip filter having fractional bandwidth up to 100% and being stable against heightened levels of power.
B.A. Belyaev +3 more
openaire +1 more source
Nonreflective microstrip filter
2016 17th International Conference of Young Specialists on Micro/Nanotechnologies and Electron Devices (EDM), 2016The article presents design for nonreflective microstrip filters based on the ring resonators and shows its calculation methods. The presented notch filter provides a high filtering due to the additional zeros of transmission index in stop band and is characterized by simplicity of design implementation.
Valentina M. Goychuk +2 more
openaire +1 more source
Single-Sided Filters in Microstrip Technology
31st European Microwave Conference, 2001, 2001This paper describes how to approach the design of microstrip filters with requirements in one passband and one stopband, both of finite extension (single-sided filters). Suitable filter topologies have been investigated, which allow having the filter passband either above or below the filter stopband.
A. Bovatti, MACCHIARELLA, GIUSEPPE
openaire +2 more sources
11th International Conference 'Microwave and Telecommunication Technology'. Conference Proceedings (IEEE Cat. No.01EX487), 2002
Broadband microstrip filters based on quarter wave irregular resonators were investigated. The possibility of realization of miniature devices with fractional bandwidth up to 100% and with highly selective properties was shown.
B.A. Belyaev +2 more
openaire +1 more source
Broadband microstrip filters based on quarter wave irregular resonators were investigated. The possibility of realization of miniature devices with fractional bandwidth up to 100% and with highly selective properties was shown.
B.A. Belyaev +2 more
openaire +1 more source

