Results 61 to 70 of about 29,245 (266)
Evaluation of the Influence of a Rail Vehicle Running with Wheel-flat on the Railway Track
Logi, 2018 The railway transport network is currently in a quite big expansion. Therefore, railway tracks are modernized and the attention is given also on the technical state of rail vehicles, which operate on them. However, it may happen that the wheel surface is
Dižo Ján +3 more
doaj +1 more source
Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys
Advanced Engineering Materials, EarlyView.Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak +3 more
wiley +1 more source
Schematization and Dynamic Analysis of Mobile Machine. Variable-Structure Systems.
Механика машин, механизмов и материалов, 2008 Approaches for modeling the complex mechanical systems of mobile machines are discussed. Basic definitions related to schematization and dynamic analyses of mechanical systems are justified.
V.B. Algin +3 more
doaj
IEEE Access, 2019 The mobile industrial human-machine interaction plays an important role in the industrial internet of things, since the engineers can use a mobile device to interact with machines that greatly improves the efficiency and safety.
Zhezhuang Xu +6 more
doaj +1 more source
Designing Soft Mobile Machines Enabled by Dielectric Elastomer Minimum Energy Structures. [PDF]
Polymers (Basel), 2022 Liu F, An N, Sun W, Zhou J.
europepmc +1 more source
Design of Mobilization System on Mobile Pulper Machine
BIO Web of ConferencesThere are several coffee pulping machines that are commonly used by farmers, but there are some drawbacks to these pulping machines. For example, a pulper machine with a large construction does not allow peeling in the coffee harvesting area. The purpose of this research is to design and build a prototype of a mobile wet coffee peeling machine (pulper).
Rinaldi Muh. +3 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.The temperature dependence of fatigue behavior in nickel‐based superalloys is investigated through high‐resolution measurements of plastic localization. While increasing temperature reduces localization and enhances fatigue performance in René 88DT, Inconel 718 exhibits a sharp degradation at intermediate temperature due to intensified slip ...
M. Calvat +5 more
wiley +1 more source
On Development of Automated Drive Systems for Domestic Mobile Engineering. Part 2
Механика машин, механизмов и материалов, 2016 This article addresses the problem of creating automated drives with automatic transmissions for domestically produced mobile machines. An analysis of main types of automatic transmissions (hydromechanical, automatedmechanical, dual clutch, hybrid ...
Leonid G. Krasnevsky, Sergei N. Poddubko
doaj
Development of robotics technologies in agriculture
MATEC Web of Conferences, 2018 The assessment of the resource potential of agriculture of the Russian Federation was given. The main factors that determine a more complete use of the potential available in the industry were defined.
Mashkov Konstantin +2 more
doaj +1 more source
A Factorization Machine-Based QoS Prediction Approach for Mobile Service Selection
IEEE Access, 2019 Mobile services allow us to access the abundant and various resources (including data and services) on the Internet or devices in the physical world via wireless network technologies.
Mingdong Tang +3 more
doaj +1 more source