Results 1 to 10 of about 86,065 (315)
Automation of Experimental Modal Analysis Using Bayesian Optimization
The dynamic characterization of structures by means of modal parameters offers many valuable insights into the vibrational behavior of these structures. However, modal parameter estimation has traditionally required expert knowledge and cumbersome manual
Johannes Ellinger +4 more
doaj +1 more source
Damage Identification And Quantification Of Structures By Vibration-Based Model Updating Method Using Teaching-Learning-Based Optimization [PDF]
Engineering structures are prone to damage over their service life as a result of natural disaster so that damage spreading may lead to many casualties. In order to prevent these catastrophic events, early damage detection must be carried out.
A. Kaveh, S.M. Hosseini, F. Barzinpour
doaj +1 more source
Sensitivity Analysis of Modal Parameters of a Jacket Offshore Wind Turbine to Operational Conditions
Accurate estimation of offshore wind turbine (OWT) modal parameters has a prominent effect on the design loads, lifetime prediction, and dynamic response of the system. Modal parameters can vary during the operation of OWTs.
Nasim Partovi-Mehr +5 more
doaj +1 more source
Dynamic Scaling of a Wing Structure Model Using Topology Optimization
In this paper, a dynamic scaling methodology is introduced to devise reduced scaled models of aircraft with the objectives of minimizing the development cost and exploring the design space.
Éder Oliveira +4 more
doaj +1 more source
Uncertainties on modal parameters by operational modal analysis [PDF]
Lorsqu’on fait une analyse modale opérationnelle sur des structures en fonctionnement, sans connaître les forces de perturbation, ni le nombre de fréquences importantes qui excitent le système mécanique, on doit se poser la question sur la validité de l’estimation des paramètres modaux (notamment le taux d’amortissement) et sur la précision des ...
Vu, Viet-Hung, Thomas, Marc
openaire +2 more sources
Structural health monitoring (SHM) is crucial for ensuring the safety and performance of offshore platforms. SHM uses advanced sensor systems to detect and respond to negative changes in structures, improving their reliability and extending their life ...
Marzieh Zamani Kouhpangi +2 more
doaj +1 more source
Parameter Identification of Bladed Assemblies Using a Subspace Method [PDF]
This paper is aimed at identifying a dynamical model for bladed assemblies such as turbines. Unknown excitation forces are applied to bladed disk assemblies leading to forced vibration responses.
Salhi Bendali +2 more
doaj +1 more source
An experimental proof-of-concept for damage detection in composite beams using modal analysis has been conducted. The purpose was to demonstrate that damage features can be detected, located, and measured on the surface of a relatively complex thin-wall ...
Josué Pacheco-Chérrez +2 more
doaj +1 more source
A novel method for identification of damage location in frame structures using a modal parameters-based indicator [PDF]
Diverse strategies for identifying and finding the damages in structures have been continuously engaging to originators within the field. Due to the direct connection between the firmness, characteristic frequency, and mode shapes within the structure ...
Mina Roodgar Nashta +3 more
doaj +1 more source
Modal parameter identification of a MEMS gyroscope [PDF]
This paper reports the experimental system identification of the Jet Propulsion Laboratory microelectromechanical (MEMS) vibrational rate gyroscope. A high-order two-input/two-output transfer function for the microgyroscope is identified and mapped to a three-mode rigid plate model that reveals the orientation of important vibrational modes.
Robert T. M'Closkey +2 more
openaire +2 more sources

